If you found this page, you probably have a problem and you need a user manual for the device Fujitsu FMWSP9. Be sure to check that it is the user manual to exactly the device that you are looking for. In our database Fujitsu FMWSP9 it belongs to the category Surge Protector. A user manualFujitsu FMWSP9 is taken from the manufacturer, a Fujitsu company - it is an official document, so if you have any doubts as to its contents, please contact the manufacturer of the device Fujitsu FMWSP9 directly. You can view the user manualFujitsu FMWSP9 directly online or save and store it on your computer.

FMWSP9  

Screen Protector  

Installation Instructions  

3

4

.

.

Install the screen protector on the pen tablet or  

harsh environment case. Apply the adhesive side to  

the screen with the notch in the lower left corner, as  

shown in Figure 3.  

PenCentra 130  

The FMWSP9 screen protector can be installed on  

the PenCentra 130 pen tablet display screen or on  

the display window of the FMWCC36 harsh  

environment case. Note the following:  

Apply pressure along the edges of the screen  

protector with your finger. (Avoid lifting the screen  

protector from the screen after it is installed. The  

adhesive requires 48 hours to cure properly.)  

•

Before installing a new screen protector, remove  

any screen protector that is already installed. A  

notch in the corner of the screen protector allows  

you to slide your fingernail or a firm, pliable  

implement (such as a credit card) under the screen  

protector for removal. Do not use a metal  

implement; it could scratch the screen.  

•

To ensure good adhesion, clean the display screen  

with a soft cotton cloth dampened with denatured  

alcohol before installing the screen protector. When  

the alcohol dries, it may leave streaks on the  

screen. If streaking occurs, buff the screen gently  

with a clean, dry cloth to remove the streaks.  

1.  

The step is for installation on the harsh  

environment case (HEC) only: Remove edge  

from screen protector, as shown in Figure 1.  

Figure 3. Installing the Screen Protector  

5

.

Remove the protective film from the top of the  

screen protector, as shown in Figure 4.  

Figure 1. Removing Edge for HEC Installation  

2.  

Peel the protective film from the adhesive side of  

the screen protector, as shown in Figure 2.  

Figure 4. Removing the Protective Film  

6

.

Wipe the exposed surface of the screen protector  

with a clean dry cloth to remove any adhesive left  

behind by the protective film.  

Figure 2. Peeling Protective Film  

PenCentra 130 is a trademark of Fujitsu Personal Systems, Inc. © 1999 Fujitsu Personal Systems, Inc.  

9/99  

58-0674-00B  

• ← Previous
• Next page →

In addition to the user manual Fujitsu FMWSP9, we also provide a support panel to help you solve your problems with Fujitsu FMWSP9. If you have any questions, you can ask them in the form below. Other users viewing this website will have the opportunity to help you solve your probem with Fujitsu FMWSP9. Remember that you can also share the solution. If you solved the problem yourself, please write the solution to the problem with Fujitsu FMWSP9 - you will surely help many users by doing so.