User manual A.O. Smith ST 3000

If you found this page, you probably have a problem and you need a user manual for the device A.O. Smith ST 3000. Be sure to check that it is the user manual to exactly the device that you are looking for. In our database A.O. Smith ST 3000 it belongs to the category Electric Heater. A user manualA.O. Smith ST 3000 is taken from the manufacturer, a A.O. Smith company - it is an official document, so if you have any doubts as to its contents, please contact the manufacturer of the device A.O. Smith ST 3000 directly. You can view the user manualA.O. Smith ST 3000 directly online or save and store it on your computer.

2.3 Commissioning  
2
.3.1 Filling the tank  
1
2
3
. Check if any installed drain valve is closed.  
. Open the cold-water supply valve to the heater  
. Open all hot-water outlets in order to bleed all air from the system. The heater is  
filled when cold water runs out of all outlets.  
4
. Close all hot water taps  
2
.3.2 Start up  
Check if the heater is filled with water and that the primary system is ready. Open water  
supply and return valves.  
2
.4 Shutting down  
For longer periods:  
1
1
. Close the cold-water tap.  
. If there is any risk of frost damage, drain the tank completely.  
2
.5 Maintenance  
The heater must be checked and cleaned regularly (at least once a year) by an accredited  
installer, so that correct operation is guaranteed.  
2
.5.1 Anodes  
The life of the anode is determined by the quality and quantity of the water flowing  
through the heater. Therefore, we recommend the anodes to be checked regularly –  
preferably simultaneously with an internal inspection of the glass-lined tank. In order to  
determine the frequency of replacement of the anode, the waterside of the boiler must be  
checked three months after installation. The anodes must be replaced, if more than 60%  
has dissolved at any point on their length.  
Procedure:  
1
2
3
4
5
. Close the cold-water inlet tap.  
. Relieve pressure from the heater completely by opening a hot water tap.  
. Remove the insulation package.  
. Unscrew and inspect the anode. Replace when used for more than 60 %.  
. Replace the anode. Attention: the anode must be in contact with the metal tank. If  
the tank and the anode are electrically isolated, the anode cannot function. This  
could have a negative effect on the life of the tank.  
6
7
. Assemble everything in reverse order.  
. Fill the heater as described in par. 2.2.1.  
6

In addition to the user manual A.O. Smith ST 3000, we also provide a support panel to help you solve your problems with A.O. Smith ST 3000. If you have any questions, you can ask them in the form below. Other users viewing this website will have the opportunity to help you solve your probem with A.O. Smith ST 3000. Remember that you can also share the solution. If you solved the problem yourself, please write the solution to the problem with A.O. Smith ST 3000 - you will surely help many users by doing so.

Have you got problems with your device? Ask a question - our users can help you

No one has added a comment for this device/ user manual.