User manual Delta 23-640

If you found this page, you probably have a problem and you need a user manual for the device Delta 23-640. Be sure to check that it is the user manual to exactly the device that you are looking for. In our database Delta 23-640 it belongs to the category Grinder. A user manualDelta 23-640 is taken from the manufacturer, a Delta company - it is an official document, so if you have any doubts as to its contents, please contact the manufacturer of the device Delta 23-640 directly. You can view the user manualDelta 23-640 directly online or save and store it on your computer.

2
hole of frame (B) and fasten in place with 1/4-20x3/4"  
carriage head screw (G), 5/16” lock washer (H), and 1/4-  
. Insert the short end of mounting rod (F) Fig. 7, into  
H
G
F
20 hex nut (I).  
B
I
Fig. 7  
Fig. 8  
Fig. 9  
3
Fig. 8, to the side of each wheel guard using bracket (J),  
/8" lockwasher and locking knob (L). The eye shield (A)  
is fully adjustable so it can be put in any position by  
moving the shield (A) or loosening locking knob (L) and  
repositioning rod (F).  
. Assemble long end of eye shield mounting rod (F)  
F
3
J
L
A
FASTENING GRINDER TO  
SUPPORTING SURFACE  
IF DURING OPERATION THERE IS ANY TENDENCY  
FOR THE GRINDER TO TIP OVER, SLIDE OR  
“WALK,” THE GRINDER MUST BE SECURED TO THE  
SUPPORTING SURFACE THROUGH THE TWO  
HOLES (A) Fig. 9, IN THE GRINDER BASE.  
A
A
CONNECTING TOOL TO POWER SOURCE  
POWER CONNECTIONS  
A separate electrical circuit should be used for your tools. This circuit should not be less than #12 wire and should  
be protected with a 20 Amp time lag fuse. If an extension cord is used, use only 3-wire extension cords which have  
3-prong grounding type plugs and 3-pole receptacles which accept the tool’s plug. Before connecting the motor to  
the power line, make sure the switch is in the “OFF” position and be sure that the electric current is of the same  
characteristics as indicated on the tool. All line connections should make good contact. Running on low voltage will  
damage the motor.  
MOTOR SPECIFICATIONS  
Your tool is wired for 120 volt, 60 HZ alternating current. Before connecting the tool to the power source, make sure  
the switch is in the “OFF” position. The motor provides a no-load speed of 3450 RPM.  
GROUNDING INSTRUCTIONS  
WARNING: THIS TOOL MUST BE GROUNDED WHILE IN USE TO PROTECT THE OPERATOR FROM  
ELECTRIC SHOCK.  
7

In addition to the user manual Delta 23-640, we also provide a support panel to help you solve your problems with Delta 23-640. If you have any questions, you can ask them in the form below. Other users viewing this website will have the opportunity to help you solve your probem with Delta 23-640. Remember that you can also share the solution. If you solved the problem yourself, please write the solution to the problem with Delta 23-640 - you will surely help many users by doing so.

Have you got problems with your device? Ask a question - our users can help you

No one has added a comment for this device/ user manual.