User manual Better Light 7

If you found this page, you probably have a problem and you need a user manual for the device Better Light 7. Be sure to check that it is the user manual to exactly the device that you are looking for. In our database Better Light 7 it belongs to the category Digital Camera. A user manualBetter Light 7 is taken from the manufacturer, a Better Light company - it is an official document, so if you have any doubts as to its contents, please contact the manufacturer of the device Better Light 7 directly. You can view the user manualBetter Light 7 directly online or save and store it on your computer.

3. Connect the AC power to the control unit  
Use only an approved power cord with a plug  
appropriate for the power receptacles of the region.  
Te camera has an external universal power adapter,  
able to operate from any AC voltage between 100  
and 240 volts nominal, 47 to 63 Hz single phase,  
without changing switches or jumpers. Te camera  
consumes a maximum of about 60 watts of power,  
and should be operated from the same circuit sup-  
plying power to the computer connected to the  
camera. Approved extension cords may be used to  
supply power to the camera over considerable distances.  
4. Turn on the digital camera  
ꢀurn on the digital camera with the switch on the control unit. Te Power LED will light green  
to indicate the unit has been turned on. When the Status LED next to the power switch goes out the  
digital camera is ready. Also check the LED on the insert, next to the cable connector. Te LED will  
flash green every few seconds to indicate a good connection with the control unit.  
5. Turn on the host computer  
ꢀurn on the host computer. While the computer  
is starting up, Steps 6 through 8 can be completed.  
6
. Install the viewing overlay on the  
camera’s ground glass  
Te scanning insert covers an image area of 72  
x 96 mm. (2.83 x 3.78 in.), slightly smaller than  
standard 4x5 sheet film, centered in the overall image  
area. Several black plastic viewing masks have been  
supplied with the digital camera, which can be placed  
over the ground glass of your camera to indicate the  
area available for digital imaging. Tese masks have  
a low-tack adhesive on one side, allowing them to be  
secured to either the inside or outside of the ground  
glass, yet easily removable. Line up the centering  
notches in the inside of the mask with the center lines  
Overlay mounted on a ground glass view screen.  
15  

In addition to the user manual Better Light 7, we also provide a support panel to help you solve your problems with Better Light 7. If you have any questions, you can ask them in the form below. Other users viewing this website will have the opportunity to help you solve your probem with Better Light 7. Remember that you can also share the solution. If you solved the problem yourself, please write the solution to the problem with Better Light 7 - you will surely help many users by doing so.

Have you got problems with your device? Ask a question - our users can help you

No one has added a comment for this device/ user manual.