This product complies with the radio
interference requirements of the European
Community. This product complies with the
requirements of the following directives and
guidelines: 2006/95/EC, 2004/108/EC.
Safety and important notice
This product is in compliance with the EEE
Risk of overheating! Never install the DVD player
in a con\ned space. Always leave a space of at least
four inches around the DVD player for ventilation.
Ensure the curtains or other objects never cover the
ventilation slots on the DVD player.
Never place the DVD player, remote control or
batteries near naked ]ames or other heat sources,
including direct sunlight.
Only use this DVD player indoors. Keep this DVD
player away from water, moisture and liquid-\lled
Never place this DVD player on other electrical
About Progressive Scan
Consumers should note that not all high de\nition
television sets are fully compatible with this
product and may cause artifacts to be displayed in
the picture. In case of 525 or 625 progressive scan
picture problems, it is recommended that the user
switch the connection to the ‘standard de\nition’
output. If there are questions regarding our TV set
compatibility with this model 525p and 625p
DVD player, please contact our customer service
Keep away from this DVD player during lightning
Where the mains plug or an appliance coupler is
used as the disconnect device, the disconnect device
shall remain readily operable.
Visible and invisible laser radiation when open. Avoid
exposure to beam.
Mains fuse (U.K. only)
This DVD player is \tted with an approved
moulded plug. Should it become necessary to
replace the mains fuse, this must be replaced
with a fuse of the same value as indicated on
the plug (example 10A).
Your product is designed and manufactured
with highly quality material and components,
which can be recycled and reused. When this
crossed-out wheeled bin symbol is attached to
a product, it means the product is covered by
the European Directive 2002/96/EC.
Remove fuse cover and fuse.
The replacement fuse must comply with BS
362 and have the ASTA approval mark. If
the fuse is lost, contact your dealer in
order to verify the correct type.
Re\t the fuse cover.
In order to maintain conformity to the
EMC directive, the mains plug on this
product must not be detached from the