User manual Panasonic CF-18

If you found this page, you probably have a problem and you need a user manual for the device Panasonic CF-18. Be sure to check that it is the user manual to exactly the device that you are looking for. In our database Panasonic CF-18 it belongs to the category Laptop. A user manualPanasonic CF-18 is taken from the manufacturer, a Panasonic company - it is an official document, so if you have any doubts as to its contents, please contact the manufacturer of the device Panasonic CF-18 directly. You can view the user manualPanasonic CF-18 directly online or save and store it on your computer.

Read Me First  
For U.S.A.  
Federal Communications Commission Radio  
Frequency Interference Statement  
FCC Regulation Notice for modem  
This equipment contains a FCC approved modem.  
Note:This equipment has been tested and found to comply with  
the limits for a Class B digital device, pursuant to Part 15 of the  
FCC Rules. These limits are designed to provide reasonable  
protection against harmful interference in a residential  
installation. This equipment generates, uses and can radiate radio  
frequency energy and, if not installed and used in accordance  
with the instructions, may cause harmful interference to radio  
communications. However, there is no guarantee that  
interference will not occur in a particular installation. If this  
equipment does cause harmful interference to radio or television  
reception, which can be determined by turning the equipment  
off and on, the user is encouraged to try to correct the interference  
by one or more of the following measures:  
Manufacturer of modem: AMBIT Microsystems Corporation  
Model No. T60M283.** (** = numbers or alphabet letters)  
Tested To Comply  
With FCC Standards  
FOR HOME OR OFFICE USE  
1
. This equipment complies with CFR47 Part 68 rules. On the  
computer is a label that contains, among other information,  
the FCC registration number and ringer equivalence number  
(
be provided to the telephone company.  
REN) for this equipment. If required, this information must  
2
. An FCC compliant telephone cord and modular plug is pro-  
vided with this equipment. This equipment is designed to be  
connected to the telephone network or premises wiring us-  
ing a compatible modular jack which is Part 68 compliant.  
See Installation Instructions for details.  
Reorient or relocate the receiving antenna.  
Increase the separation between the equipment and receiver.  
Connect the equipment into an outlet on a circuit different  
from that to which the receiver is connected.  
Consult the Panasonic Service Center or an experienced ra-  
dio/TV technician for help.  
3. The REN is used to determine the quantity of devices which  
may be connected to the telephone line. Excessive RENs on  
the telephone line may result in the devices not ringing in re-  
sponse to an incoming call. In most, but not all area, the sum  
of RENs should not exceed five (5.0). To be certain of the  
number of devices that may be connected to a line, as deter-  
mined by the total RENs, contact the local telephone com-  
pany.  
Warning  
To assure continued compliance, use only shielded interface  
cables when connecting to a computer or peripheral. Also,  
any changes or modifications not expressly approved by the  
party responsible for compliance could void the user’s author-  
ity to operate this equipment.  
FCC RF Exposure Warning:  
This equipment complies with FCC radiation exposure lim-  
its set forth for an uncontrolled environment.  
4
. If your telephone equipment cause harm to the telephone net-  
work, the telephone company will notify you in advice that  
temporary discontinuance of service may be required. But if  
advice notice isn’t practical, the telephone company will no-  
tify the customer as soon as possible. Also, you will be ad-  
vised of your right to file a complaint with the FCC if you  
believe it is necessary.  
This equipment has been approved for portable operation,  
and unless otherwise advised in separate supplemental in-  
structions for individual wireless transmitter(s), requires  
minimum 1.5 cm spacing be provided between antenna(s)  
and all person’s body (excluding extremities of hands, wrist  
and feet) during wireless modes of operation.  
This equipment may use multiple installed transmitters,  
which may be capable of simultaneous transmission.  
This equipment is provided with PC Card slot that could be  
used with wireless transmitters, which will be specifically  
recommended when they become available.  
5
. The telephone company may take changes in it’s facilities,  
equipment, operations or procedures that could affect the op-  
eration of the equipment. If this happens the telephone com-  
pany will provide advance notice in order for you to make  
necessary modifications to maintain uninterrupted service.  
6. If trouble is experienced with this equipment, for repair or  
warranty information, please contact Matsushita Electric  
Corporation of America at DIAL TOLL FREE 1-800-LAP-  
TOP5 (1-800-527-8675). If the equipment is causing harm  
to the telephone network, the telephone company may re-  
quest that you disconnect the equipment until the problem is  
resolved.  
Other third-party wireless transmitters have not been RF ex-  
posure evaluated for use with this computer and may not  
comply with FCC RF exposure requirements.  
This equipment is provided with external antenna  
connector(s) for connection to optional Car Mounter or  
Port Replicator for mobile external mounted antenna(s).  
External antenna(s) must be professionally installed and  
cannot exceed recommended maximum antenna gain as  
described in individual provided supplement instructions  
for wireless transmitters. Also, user must maintain mini-  
mum 20 cm spacing between external antenna(s) and all  
person’s body (excluding extremities of hands, wrist and  
feet) during wireless modes of operation.  
7
8
. There are no user serviceable parts contained in this equipment.  
. This equipment may not be used on coin service provided by  
the telephone company. Connection to party lines is subject  
to state tariffs.  
9
. The Telephone Consumer Protection Act of 1991 makes it  
unlawful for any person to use a computer or other electronic  
device to send any message via a telephone fax machine un-  
less such message clearly contains in a margin at the top or  
bottom of each transmitted page or on the first page of the  
transmission, the date and time it is sent and an identification  
of the business or other entry, or other individual sending the  
message and the telephone number of the sending machine  
or such business, other entity, or individual. In order to pro-  
gram this information into your fax software, you should re-  
fer to the manual of the Fax software being used.  
This device complies with Part 15 of the FCC Rules. Operation  
is subject to the following two conditions:  
(
(
1) This device may not cause harmful interference, and  
2) This device must accept any interference received, including  
interference that may cause undesired operation.  
Responsible Party:Matsushita Electric Corporation ofAmerica  
One Panasonic Way  
Secaucus, NJ 07094  
Tel No:1-800-LAPTOP-5 (1-800-527-8675)  
3

In addition to the user manual Panasonic CF-18, we also provide a support panel to help you solve your problems with Panasonic CF-18. If you have any questions, you can ask them in the form below. Other users viewing this website will have the opportunity to help you solve your probem with Panasonic CF-18. Remember that you can also share the solution. If you solved the problem yourself, please write the solution to the problem with Panasonic CF-18 - you will surely help many users by doing so.

Have you got problems with your device? Ask a question - our users can help you

No one has added a comment for this device/ user manual.