User manual Atari Marine Instruments LM-1

If you found this page, you probably have a problem and you need a user manual for the device Atari Marine Instruments LM-1. Be sure to check that it is the user manual to exactly the device that you are looking for. In our database Atari Marine Instruments LM-1 it belongs to the category Marine Instruments. A user manualAtari Marine Instruments LM-1 is taken from the manufacturer, a Atari company - it is an official document, so if you have any doubts as to its contents, please contact the manufacturer of the device Atari Marine Instruments LM-1 directly. You can view the user manualAtari Marine Instruments LM-1 directly online or save and store it on your computer.

G3 Air/Fuel Gauge  
LM-1 Quick Start Guide  
G3 Air/Fuel Gauge  
LC-1 Quick Start Guide  
The LM-1’s analog output cable has three ends: Red wire  
is analog output 1, White wire is analog output 2, and the  
remaining wire is the ground. In these instructions we  
will be using the white and ground wires.  
1
2
. Wire the LC-1 per the unit’s instructions  
. Connect the gauge’s BROWN wire to a permanent/constant  
2 volt source.  
1
1
2
. Connect the gauge’s BROWN wire to a permanent/constant 12 volt  
3
. Connect the gauge’s BLACK ground wire at the LC-1’s  
White ground point. This ground point should ideally be an  
engine block ground.  
source.  
. Connect the gauge’s BLACK ground wire to the LM-1’s analog  
output wire’s ground.  
4
. Connect the gauge’s GREEN wire to the LC-1’s Brown  
analog output 2. The gauge is setup to work with the LC-1’s  
analog output 2 factory default setting of 0v = 7.35 A/F and  
3. Connect the gauge’s GREEN wire to the white analog output wire.  
4. Connect the gauge’s WHITE and BLUE wires to a switched  
12 volt source (ignition switched).  
5
v = 22.39 A/F.  
. Connect the gauge’s WHITE and BLUE wires to a switched  
2 volt source (ignition switched).  
5. Connect the LM-1 to the computer and launch LM Programmer.  
Setup analog output 2 as 0v = 7.35 A/F and 5v = 22.39 A/F. Lastly  
click on the “Program” button.  
5
1
Optional Tip/Trick (requires connection of LC-1 to PC)  
The LC-1 can be programmed to output specific voltages during  
warm-up and error conditions. This can be done by connecting  
the LC-1 to the computer and launching LM Programmer. The  
warm-up and error condition options for the analog output are  
under the Advanced… settings. For example, if you setup the  
error condition at 5V your gauge will display full lean if any  
problem arises. Please refer to chapter 6.5.1 in the LC-1 manual  
for further information.  
1
1-0116 g3 gauge.doc  

In addition to the user manual Atari Marine Instruments LM-1, we also provide a support panel to help you solve your problems with Atari Marine Instruments LM-1. If you have any questions, you can ask them in the form below. Other users viewing this website will have the opportunity to help you solve your probem with Atari Marine Instruments LM-1. Remember that you can also share the solution. If you solved the problem yourself, please write the solution to the problem with Atari Marine Instruments LM-1 - you will surely help many users by doing so.

Have you got problems with your device? Ask a question - our users can help you

No one has added a comment for this device/ user manual.