User manual Sony ICFC1IPMK2

If you found this page, you probably have a problem and you need a user manual for the device Sony ICFC1IPMK2. Be sure to check that it is the user manual to exactly the device that you are looking for. In our database Sony ICFC1IPMK2 it belongs to the category MP3 Player. A user manualSony ICFC1IPMK2 is taken from the manufacturer, a Sony company - it is an official document, so if you have any doubts as to its contents, please contact the manufacturer of the device Sony ICFC1IPMK2 directly. You can view the user manualSony ICFC1IPMK2 directly online or save and store it on your computer.

Owner’s Record  
Important Safety Instructions  
The model number and the serial number are located  
on the rear exterior.  
1) Read these instructions.  
Connecting the antenna  
2) Keep these instructions.  
3) Heed all warnings.  
4) Follow all instructions.  
5) Do not use this apparatus near water.  
6) Clean only with dry cloth.  
7) Do not block any ventilation openings.  
Install in accordance with the manufacturer’s  
“Specifications” .  
Operate the unit on the power sources specified in  
Record the serial number in the space provided below.  
Refer to them whenever you call upon your Sony  
dealer regarding this product.  
To connect the AM loop antenna  
The shape and the length of the antenna is designed to  
receive AM signals. Do not dismantle or roll up the  
To disconnect the power cord (mains lead), pull it  
out by the plug, not the cord.  
Model No. ICF-C1iPMK2  
Serial No.  
The unit is not disconnected from the AC power  
source (mains) as long as it is connected to the wall  
outlet, even if the unit itself has been turned off.  
Remove only the loop part from the plastic  
Set up the AM loop antenna.  
Do not leave the unit in a location near a heat  
source, such as a radiator or airduct, or in a place  
subject to direct sunlight, excessive dust, mechanical  
vibration, or shock.  
For customers who purchased this product in the  
8) Do not install near any heat sources such as  
radiators, heat registers, stoves, or other apparatus  
(including amplifiers) that produce heat.  
Please register this product on line at  
Proper registration will enable us to send you  
periodic mailings about new products, services,  
and other important announcements. Registering  
your product will also allow us to contact you in  
the unlikely event that the product needs  
adjustment or modification. Thank you.  
Do not defeat the safety purpose of the polarized  
or grounding-type plug. A polarized plug has two  
blades with one wider than the other. A grounding  
type plug has two blades and a third grounding  
prong. The wide blade or the third prong are  
provided for your safety. If the provided plug does  
not fit into your outlet, consult an electrician for  
replacement of the obsolete outlet.  
Allow adequate air circulation to prevent internal  
heat build-up. Do not place the unit on a surface (a  
rug, blanket, etc.) or near materials (a curtain) that  
might block the ventilation holes.  
FM/AM Clock Radio  
Should any solid object or liquid fall into the unit,  
unplug the unit and have it checked by qualified  
personnel before operating it any further.  
To clean the casing, use a soft cloth dampened with  
a mild detergent solution.  
Connect the cords to the AM antenna  
The cords (A and B) can be connected to either  
0) Protect the power cord from being walked on or  
pinched particularly at plugs, convenience  
receptacles, and the point where they exit from the  
Operating Instructions  
To reduce the risk of fire or electric shock, do not  
expose this apparatus to rain or moisture.  
To reduce the risk of electrical shock, do not open  
the cabinet. Refer servicing to qualified  
personnel only.  
Insert the cord while  
pushing down the  
terminal clamp.  
Wipe the battery with a dry cloth to assure a good  
11) Only use attachments/accessories specified by the  
12) Use only with the cart, stand, tripod, bracket, or  
table specified by the manufacturer, or sold with  
the apparatus. When a cart is used, use caution  
when moving the cart/apparatus combination to  
avoid injury from tip-over.  
Be sure to observe the correct polarity when  
installing the battery.  
Do not hold the battery with metallic tweezers,  
otherwise a short-circuit may occur.  
To reduce the risk of fire, do not cover the ventilation  
of the apparatus with newspapers, tablecloths,  
curtains, etc. And do not place lighted candles on the  
The apparatus shall not be exposed to dripping or  
splashing and that no objects filled with liquids, such  
as vases, shall be placed on the apparatus.  
If you have any questions or problems  
concerning your unit, please consult your nearest  
Sony dealer.  
Do not install the appliance in a confined space, such  
as a bookcase or built-in cabinet.  
Time display  
12-hour System  
3) Unplug this apparatus during lightning storms or  
when unused for long periods of time.  
Make sure the AM loop antenna is  
connected firmly by pulling softly.  
As the main plug is used to disconnect the unit from  
the mains, connect the unit to an easily accessible AC  
outlet. Should you notice an abnormality in the unit,  
disconnect the main plug from the AC outlet  
14) Refer all servicing to qualified service personnel.  
Servicing is required when the apparatus has been  
damaged in any way, such as power-supply cord or  
plug is damaged, liquid has been spilled or objects  
have fallen into the apparatus, the apparatus has  
been exposed to rain or moisture, does not operate  
normally, or has been dropped.  
Dream Machine is a trademark of Sony Corporation.  
Adjusting the AM loop antenna  
Frequency range  
Find a place and an orientation that provide good  
87.5 – 108 MHz  
530 – 1 710 kHz  
Channel step  
0.1 MHz  
10 KHz  
You are cautioned that any changes or  
modifications not expressly approved in this manual  
could void your authority to operate this equipment.  
Do not place the AM loop antenna near the unit or  
other AV equipment, as noise may result.  
If you use an external polarized AM antenna, be sure  
to connect the ground cord to the terminal. The  
supplied AM antenna cord has no polarity.  
No Power No Problem is a trademark of Sony Corporation.  
For the state of california, USA only  
Approx. 5.1 cm (2 inches) dia., 12 Ω  
Perchlorate Material –special handling may apply, See  
Perchlorate Material: Lithium battery contains  
Power output  
3 W + 3 W (at 10% harmonic distortion)  
Adjust the direction of the AM loop antenna for best  
AM broadcast sound.  
Power requirements  
20 V AC, 60 Hz  
For clock backup: 3 V DC, one CR2032 battery  
2008 Sony Corporation Printed in China  
Dual alarm FM/AM Clock radio with iPod dock.  
Various type of alarms- iPod, radio and buzzer.  
Approx. 300 × 1301× 139 mm (w/h/d)  
16 × 5 × 5 inches) incl. projecting parts  
and controls  
Automatic time set — When you plug the clock in  
for the first time, the current time will be shown in  
the display.  
Approx. 1.8 kg (3 lb 15.4 oz) incl. CR2032 battery  
This symbol is intended to alert the user  
to the presence of uninsulated “dangerous  
voltage” within the product’s enclosure  
that may be of sufficient magnitude to  
constitute a risk of electric shock to  
Automatic Daylight Saving Time/Summer time  
CLOCK button to display month, day and year.  
Supplied accessories  
Remote commander (1)  
Audio connecting cable (1)  
AM loop antenna (1)  
Brightness control (High/Middle/Low).  
No Power No Problem alarm system to keep the  
clock and the alarm operating during a power  
interruption with a CR2032 battery installed.  
This symbol is intended to alert the user  
to the presence of important operating  
and maintenance (servicing) instructions  
in the literature accompanying the  
Design and specifications are subject to change  
without notice.  
Should any problem occur with the unit, make the  
following simple checks to determine whether or not  
servicing is required.  
Class II equipment symbol This symbol  
indicates that the unit has a double  
insulation system.  
If the problem persists, consult your nearest Sony  
This equipment has been tested and found to comply  
with the limits for a Class B digital device, pursuant to  
Part 15 of the FCC Rules. These limits are designed to  
provide reasonable protection against harmful  
The clock displays “AM 12:00” due to a power  
The battery is low. Replace the battery. Remove the  
old battery and install a new one.  
interference in a residential installation. This  
equipment generates, uses and can radiate radio  
frequency energy and, if not installed and used in  
accordance with the instructions, may cause harmful  
interference to radio communications. However, there  
is no guarantee that interference will not occur in a  
particular installation. If this equipment does cause  
harmful interference to radio or television reception,  
which can be determined by turning the equipment  
off and on, the user is encouraged to try to correct the  
interference by one or more of the following measures:  
When daylight saving time begins, the clock does  
not employ the daylight saving time  
Make sure the clock is set correctly.  
Press and hold CLOCK and TIME ZONE/ALARM  
DISPLAY simultaneously for at least two seconds to  
employ the DST function.  
The alarm does not sound at the preset alarm  
Reorient or relocate the receiving antenna.  
Increase the separation between the equipment  
and receiver.  
Has the desired alarm been activated? (i.e., Does the  
ALARM A (or B) indicator light up?)  
Connect the equipment into an outlet on a circuit  
different from that to which the receiver is  
The radio or iPod alarm is activated but no sound  
comes on at the preset alarm time.  
Has VOLUME been adjusted?  
Consult the dealer or an experienced radio/TV  
technician for help.  
There is no sound from the iPod.  
Make sure the iPod is securely connected.  
Adjust the VOLUME.  
Danger of explosion if battery is incorrectly  
replaced. Replace only with the same or equivalent  
The iPod cannot be operated with this unit.  
Make sure the iPod is securely connected.  
Replace the battery for the clock backup with a Sony  
CR2032 lithium battery, and the battery for the  
remote commander with a Sony CR2025 lithium  
battery. Use of another battery may present a risk of  
fire or explosion.  
The iPod cannot be charged.  
Make sure the iPod is securely connected.  
Battery may explode if mistreated. Do not recharge,  
disassemble or dispose of in fire.  
Do not expose the battery to excessive heat such as  
direct sunlight, fire or the like.  
Dispose of used battery promptly. Keep away from  
This unit includes a preinstalled Sony Lithium battery (CR2032) as back-up power source for the clock, which is preset  
to EST/EDT (Eastern Standard Time/Daylight Time) at the factory. And this battery is considered part of the product.  

In addition to the user manual Sony ICFC1IPMK2, we also provide a support panel to help you solve your problems with Sony ICFC1IPMK2. If you have any questions, you can ask them in the form below. Other users viewing this website will have the opportunity to help you solve your probem with Sony ICFC1IPMK2. Remember that you can also share the solution. If you solved the problem yourself, please write the solution to the problem with Sony ICFC1IPMK2 - you will surely help many users by doing so.

Have you got problems with your device? Ask a question - our users can help you

No one has added a comment for this device/ user manual.