User manual Whirlpool GXW6530DXS

If you found this page, you probably have a problem and you need a user manual for the device Whirlpool GXW6530DXS. Be sure to check that it is the user manual to exactly the device that you are looking for. In our database Whirlpool GXW6530DXS it belongs to the category Range. A user manualWhirlpool GXW6530DXS is taken from the manufacturer, a Whirlpool company - it is an official document, so if you have any doubts as to its contents, please contact the manufacturer of the device Whirlpool GXW6530DXS directly. You can view the user manualWhirlpool GXW6530DXS directly online or save and store it on your computer.

For Non-Vented (recirculating) Installations  
If it is not possible to vent cooking fumes and vapors to the  
outside, the hood can be used in the non-vented (recirculating)  
version, fitting a charcoal filter and the deflector. Fumes and  
vapors are recycled through the top grille.  
Observe all governing codes and ordinances.  
Ensure that the electrical installation is adequate and in  
conformance with National Electrical Code, ANSI/NFPA 70 (latest  
edition), or CSA Standards C22.1-94, Canadian Electrical Code,  
Part 1 and C22.2 No. 0-M91 (latest edition) and all local codes  
and ordinances.  
Roof Venting  
Wall Venting  
If codes permit and a separate ground wire is used, it is  
recommended that a qualified electrician determine that the  
ground path is adequate.  
A copy of the above code standards can be obtained from:  
National Fire Protection Association  
1 Batterymarch Park  
Quincy, MA 02169-7471  
CSA International  
501 East Pleasant Valley Road  
Cleveland, OH 44131-5575  
A 120 volt, 60 Hz., AC only, 15-amp, fused electrical circuit is  
If the house has aluminum wiring, follow the procedure  
A. Roof cap  
B. 6" (15.2 cm)  
round vent  
A. Wall cap  
B. 6" (15.2 cm)  
round vent  
A. Deflector  
B. 6" (15.2 cm)  
round vent  
Connect a section of solid copper wire to the pigtail  
Connect the aluminum wiring to the added section of  
copper wire using special connectors and/or tools  
designed and UL listed for joining copper to aluminum.  
Calculating Vent System Length  
Follow the electrical connector manufacturer's recommended  
procedure. Aluminum/copper connection must conform with  
local codes and industry accepted wiring practices.  
To calculate the length of the system you need, add the  
equivalent feet (meters) for each vent piece used in the system.  
Wire sizes and connections must conform with the rating of  
the appliance as specified on the model/serial rating plate.  
The model/serial plate is located behind the filter on the rear  
wall of the range hood.  
Vent Piece  
6" (15.2 cm) Round  
5° elbow  
0° elbow  
2.5 ft  
0.8 m)  
Wire sizes must conform to the requirements of the National  
Electrical Code, ANSI/NFPA 70 (latest edition), or CSA  
Standards C22. 1-94, Canadian Electrical Code, Part 1 and  
C22.2 No. 0-M91 (latest edition) and all local codes and  
5.0 ft  
(1.5 m)  
Maximum equivalent vent length is 35 ft (10.7 m).  
Example vent system  
Wall cap  
90 elbow  
6 ft (1.8 m)  
0.6 m)  
The following example falls within the maximum recommended  
vent length of 35 ft (10.7 m).  
- 90° elbow  
= 5.0 ft (1.5 m)  
= 0.0 ft (0.0 m)  
= 8.0 ft (2.4 m)  
- wall cap  
ft (2.4 m) straight  
Length of system  
= 13.0 ft (3.9 m)  

In addition to the user manual Whirlpool GXW6530DXS, we also provide a support panel to help you solve your problems with Whirlpool GXW6530DXS. If you have any questions, you can ask them in the form below. Other users viewing this website will have the opportunity to help you solve your probem with Whirlpool GXW6530DXS. Remember that you can also share the solution. If you solved the problem yourself, please write the solution to the problem with Whirlpool GXW6530DXS - you will surely help many users by doing so.

Have you got problems with your device? Ask a question - our users can help you

No one has added a comment for this device/ user manual.