INSTALLATION INSTRUCTIONS
PrepareLocation
8. Mark centers of the fastener locations through the template
to the wall.
■
■
■
It is recommended that the vent system be installed before
hood is installed.
IMPORTANT: All screws must be installed into wood. If there
is no wood to screw into, additional wall framing supports
may be required.
Before making cutouts, make sure there is proper clearance
within the ceiling or wall for exhaust vent.
Check your ceiling height and the hood height maximum
before you select your hood.
Remove the template.
9
.
Drill ³⁄₁₆" (4.8 mm) pilot holes at all locations where screws are
being installed into wood.
1
.
Disconnect power.
2.
Determine which venting method to use: roof, wall, or non-
vented.
1
0. Install the 2 - 5 x 45 mm mounting screws. Leave a
⁄₄" (6.4 mm) gap between the wall and the back of the
screw head to slide range hood into place.
¹
3.
Select a flat surface for assembling the range hood. Place
covering over that surface.
¹
⁄₄"
(6.4 mm)
WARNING
Excessive Weight Hazard
Use two or more people to move and install
range hood.
Vent Cover Bracket Installation
Failure to do so can result in back or other injury.
1
1. Attach vent cover bracket to wall flush to the ceiling using
2
- 5 x 45 mm screws.
4.
Using 2 or more people, lift range hood onto covered surface.
Range Hood Mounting Screws Installation
5
.
.
Determine and mark the centerline on the wall where the
canopy hood will be installed.
A
6
Select a mounting height between a minimum of
24" (61.0 cm) for an electric cooking surface, a minimum
B
of 27" (68.6 cm) for a gas cooking surface, and a suggested
maximum of 36" (91.4 cm) above the range to the bottom
of the hood. Mark a reference line on the wall.
7.
Tape template in place, aligning the template centerline and
bottom of template with hood bottom line and with the
centerline marked on the wall.
C
A
A. Ceiling
B. Wall
DRILL2(TWO)3/16"PILOTHOLESTHROUGHSTUDSORREARWALLSUPPORT
C. Centerline
REARWALL
MOUNTINGTEMPLATE
Complete Preparation
CL
ALIGNBOTTOM EDGE
WITHPENCILLINE
INDICATINGBOTTOM
OFTHEHOOD
1. Determine and make all necessary cuts in the wall for the vent
system. Install the vent system before installing the hood. See
InstallationHeight
HorizontalLine
“Venting Requirements” section.
2.
Determine the required height for the home power supply
cable and drill a 1¼" (3.2 cm) hole at this location.
B
C
A. Centerline
B. Fastener locations
C. Mounting height reference
hood bottom line)
3. Run the home power supply cable according to the National
Electrical Code or CSA Standards and local codes and
ordinances. There must be enough ½" conduit and wires from
the fused disconnect (or circuit breaker) box to make the
connection in the hood’s electrical terminal box.
(
NOTE: Do not reconnect power until installation is complete.
4. Use caulk to seal all openings.
7
Have you got problems with your device? Ask a question - our users can help you