User manual Harbor Freight Tools 94331

If you found this page, you probably have a problem and you need a user manual for the device Harbor Freight Tools 94331. Be sure to check that it is the user manual to exactly the device that you are looking for. In our database Harbor Freight Tools 94331 it belongs to the category Router. A user manualHarbor Freight Tools 94331 is taken from the manufacturer, a Harbor Freight Tools company - it is an official document, so if you have any doubts as to its contents, please contact the manufacturer of the device Harbor Freight Tools 94331 directly. You can view the user manualHarbor Freight Tools 94331 directly online or save and store it on your computer.

Router Table Insert Installation Instructions  
Note: The table may need to be cut and routed to  
accept this insert.  
1
. Decide how you want your router to be oriented in  
relation to the table.We suggest that the handles  
be aligned with the long dimension of the Table  
Insert.You also should consider the location of the  
switch, height adjustment knob & locking lever.  
2
. Be sure your Router Table Insert is in the proper  
position, with the starting pin holes to the right of  
the bit location.  
3
. Place your router upside down on top of the Router  
Table Insert, with the router in the desired position.  
You’ll be using the router baseplate as a drilling  
template. Before removing the baseplate, put a  
mark or piece of tape at the front and center of both  
the baseplate and the Router Table Insert.These  
will serve as reference points later on.  
4. Next rmove the baseplate from the router and the  
Router Table Insert from the table top.  
5
. Turn both plates upside down, and center the  
router base plate on the Router Table Insert (the  
concentric rings will help with this alignment).  
Make sure the tape or marks you placed on the  
plates in step #3 are oriented properly.  
6
. Clamp the Router Base Plate and the Router Table  
Insert together securely.  
7. Carefully drill through the table plate, using the  
holes in the router base plate as guides.  
8
. Remove clamps, turn the table plate over and  
countersink the holes you drilled in the previous  
step. Run your countersink at slow speed, and use  
care not to countersink too deep.  
9
. Mount the Router Table Insert to your router. If the  
screws supplied with your router are too short, you  
can obtain longer screws from hardware or auto-  
motive parts stores. Lower router and plate into  
table and you’re ready to go!  
SKU 94331  
Page 5  

In addition to the user manual Harbor Freight Tools 94331, we also provide a support panel to help you solve your problems with Harbor Freight Tools 94331. If you have any questions, you can ask them in the form below. Other users viewing this website will have the opportunity to help you solve your probem with Harbor Freight Tools 94331. Remember that you can also share the solution. If you solved the problem yourself, please write the solution to the problem with Harbor Freight Tools 94331 - you will surely help many users by doing so.

Have you got problems with your device? Ask a question - our users can help you

No one has added a comment for this device/ user manual.