User manual Wilton PF3-EZ

If you found this page, you probably have a problem and you need a user manual for the device Wilton PF3-EZ. Be sure to check that it is the user manual to exactly the device that you are looking for. In our database Wilton PF3-EZ it belongs to the category Saw. A user manualWilton PF3-EZ is taken from the manufacturer, a Wilton company - it is an official document, so if you have any doubts as to its contents, please contact the manufacturer of the device Wilton PF3-EZ directly. You can view the user manualWilton PF3-EZ directly online or save and store it on your computer.

Pivot  
To pivot the Stock Feeder (for maintenance, oil  
filling, etc.):  
1
.
.
Loosen the handle (E, Figure 10) and pull  
up on the pin (F, Figure 10).  
2
Pivot the Stock Feeder into position. (NOTE:  
At 90 degrees of pivot, as shown in Figure  
10, the pin will lock into place.)  
3.  
Re-tighten the handle (E, Figure 10).  
Figure 10  
Operating Controls  
Switch  
The control switch is shown in Figure 11. The  
switch can be set to either Forward or Reverse  
(
the arrows on the switch label reflect the  
direction of roller rotation).  
Never put the stock feeder  
into reverse while the table saw blade is still  
rotating. Failure to comply may cause stock  
kickback and personal injury.  
Figure 11  
Speed Selection  
The speed, or feed rate of the Stock Feeder is  
variable, ranging from 6.5 to 66 feet per minute.  
The speed is adjusted by setting the control  
switch (Figure 11) and rotating the transmission  
knob, shown in Figure 12. Rotating the  
transmission knob clockwise decreases the  
speed, counterclockwise increases it.  
The speed is established when the edge of the  
transmission knob lines up with the appropriate  
line on the speed scale. See Figure 12. The  
speed scale is graduated in feet per minute, and  
meters per minute.  
The transmission knob should only be adjusted  
when the Stock Feeder is operating; that is,  
when the control switch is in either forward or  
reverse.  
Figure 12  
Operation  
IMPORTANT: Before operating the Stock  
Feeder, you should be thoroughly familiar with  
the safety and operating instructions that  
accompanied your table saw.  
Keep hands away from  
rollers and blade area during operation.  
Failure to comply may cause injury.  
13  

In addition to the user manual Wilton PF3-EZ, we also provide a support panel to help you solve your problems with Wilton PF3-EZ. If you have any questions, you can ask them in the form below. Other users viewing this website will have the opportunity to help you solve your probem with Wilton PF3-EZ. Remember that you can also share the solution. If you solved the problem yourself, please write the solution to the problem with Wilton PF3-EZ - you will surely help many users by doing so.

Have you got problems with your device? Ask a question - our users can help you

No one has added a comment for this device/ user manual.