User manual Wilton PF3-EZ

If you found this page, you probably have a problem and you need a user manual for the device Wilton PF3-EZ. Be sure to check that it is the user manual to exactly the device that you are looking for. In our database Wilton PF3-EZ it belongs to the category Saw. A user manualWilton PF3-EZ is taken from the manufacturer, a Wilton company - it is an official document, so if you have any doubts as to its contents, please contact the manufacturer of the device Wilton PF3-EZ directly. You can view the user manualWilton PF3-EZ directly online or save and store it on your computer.

1.  
Loosen and remove the hex nut and flat  
washer on the roller shaft with a 24mm  
wrench.  
2
.
.
Remove the outer roller.  
3
Install a spacer on the shaft and flush  
against the inner roller as shown in Figure  
15.  
4
.
.
Re-install the outer roller.  
5
Install the flat washer and hex nut and  
tighten with wrench.  
6.  
Repeat for the other rollers if needed.  
Maintenance  
Before performing any  
maintenance  
on the Stock Feeder,  
disconnect it from the electrical supply by  
pulling out the plug or switching off the  
breaker. Also make sure the table saw is  
disconnected from power.  
If the power cord is worn, cut, or damaged in  
any way, have it replaced immediately.  
Figure 16  
Figure 17  
Figure 18  
Rollers  
The polyurethane rollers should be kept clean of  
grease, sawdust and other debris. Use a soft  
cloth with soap and water to wipe down the  
rollers. DO NOT use a solvent on the rollers.  
The rollers can be removed from the Stock  
Feeder for replacement or maintenance  
purposes. To remove a roller, loosen and  
remove the hex nut and flat washer (Figure 15)  
with a 24mm wrench and pull the roller(s) off the  
shaft.  
Drive Belt Replacement  
1.  
Remove the guard cover (Figure 16) by  
loosening and removing the three socket  
head cap screws with a 5mm hex wrench.  
2
.
.
Remove the old belt from around the pulley  
and install the new belt.  
3
Re-install the guard cover, making sure the  
keyway on the shaft pulley aligns with the  
key on the shaft.  
Lubrication  
Every 200 hours, or 30 days, insert grease into  
the two grease fittings on the end of the Stock  
Feeder (Figure 17), and the grease fittings on  
the tip of each sprocket shaft located inside the  
housing (Figure 18).  
15  

In addition to the user manual Wilton PF3-EZ, we also provide a support panel to help you solve your problems with Wilton PF3-EZ. If you have any questions, you can ask them in the form below. Other users viewing this website will have the opportunity to help you solve your probem with Wilton PF3-EZ. Remember that you can also share the solution. If you solved the problem yourself, please write the solution to the problem with Wilton PF3-EZ - you will surely help many users by doing so.

Have you got problems with your device? Ask a question - our users can help you

No one has added a comment for this device/ user manual.