If you found this page, you probably have a problem and you need a user manual for the device Wilton PF3-EZ. Be sure to check that it is the user manual to exactly the device that you are looking for. In our database Wilton PF3-EZ it belongs to the category Saw. A user manualWilton PF3-EZ is taken from the manufacturer, a Wilton company - it is an official document, so if you have any doubts as to its contents, please contact the manufacturer of the device Wilton PF3-EZ directly. You can view the user manualWilton PF3-EZ directly online or save and store it on your computer.

Assembly  

Tools needed for assembly (not provided):  

Electric drill  

center punch and hammer  

1

0.5mm drill bit  

M12 x P1.75 tap  

12mm and 19mm wrenches  

mm hex wrench  

4

Hardware needed for assembly (not provided):  

4

4

M12 flat washers  

M12 x P1.75 hex cap screws (length will  

depend upon thickness of saw table)  

Exposed metal areas of the Stock Feeder have  

been factory coated with a protectant. This  

should be removed with a soft cloth dampened  

with kerosene or mineral spirits. Do not use  

gasoline, acetone or lacquer thinner for this  

purpose. Do not get solvents near plastic or  

rubber parts, and do not use an abrasive pad  

because it may scratch metal surfaces.  

The Stock Feeder should be mounted securely  

to a table saw in a well-lit area. Leave enough  

space around the work area for loading and off-  

loading stock and general maintenance.  

The stock feeder and the  

table saw to which you are mounting it  

should both be disconnected from power  

during installation.  

1.  

Determine the mounting location for the  

stand. Keep in mind the overall length of the  

horizontal arm, so that after it is mounted to  

the stand it will have enough adjustment for  

positioning the Stock Feeder.  

2.  

Use the provided boring template to find the  

centerline spacing for the holes in the base  

of the stand. Clean the table surface, then  

remove the backing from the boring  

template and carefully stick the boring  

template into place on the mounting surface.  

(

NOTE: This template is also on page 27.)  

3.  

Center punch and drill four 10.5 mm  

diameter holes in the surface, then tap the  

holes with M12 x P1.75 threads.  

4

.

.

Peel off the boring template and discard.  

5

Place the stand in position, align the four  

holes in the stand with the holes in the table,  

and insert four M12 hex cap screws with  

four M12 flat washers (not provided). See  

Figure 1.  

Figure 1  

9

• ← Previous
• Next page →

In addition to the user manual Wilton PF3-EZ, we also provide a support panel to help you solve your problems with Wilton PF3-EZ. If you have any questions, you can ask them in the form below. Other users viewing this website will have the opportunity to help you solve your probem with Wilton PF3-EZ. Remember that you can also share the solution. If you solved the problem yourself, please write the solution to the problem with Wilton PF3-EZ - you will surely help many users by doing so.