User manual Skil 1677M

If you found this page, you probably have a problem and you need a user manual for the device Skil 1677M. Be sure to check that it is the user manual to exactly the device that you are looking for. In our database Skil 1677M it belongs to the category Saw. A user manualSkil 1677M is taken from the manufacturer, a Skil company - it is an official document, so if you have any doubts as to its contents, please contact the manufacturer of the device Skil 1677M directly. You can view the user manualSkil 1677M directly online or save and store it on your computer.

BM 1619X01743 08-06 8/17/06 8:48 AM Page 11  
Allow blade to come to a Turn saw around and finish the cut in the normal  
WARNING  
complete stop before lifting manner, sawing forward. If corners of your  
!
the saw from cut. Also, never pull the saw pocket cut are not completely cut through, use a  
backward since blade will climb out of the jigsaw or hand saw to finish the corners.  
material and KICKBACK will occur.  
CUTTING LARGE SHEETS  
WRONG  
Large sheets and long boards sag or bend,  
depending on support. If you attempt to cut  
without leveling and properly supporting the  
piece, the blade will tend to bind, causing KICK-  
BACK and extra load on the motor (Fig. 8).  
FIG. 8  
Support the panel or board close to the cut, as  
shown in (Fig. 9). Be sure to set the depth of the  
cut so that you cut through the sheet or board  
only and not the table or work bench. The two-  
by-fours used to raise and support the work  
should be positioned so that the broadest sides  
support the work and rest on the table or bench.  
Do not support the work with the narrow sides  
as this is an unsteady arrangement. If the sheet  
or board to be cut is too large for a table or work  
bench, use the supporting two-by-fours on the  
floor and secure.  
RIGHT  
FIG. 9  
RIP CUTS  
RIP BOARD GUIDE  
The combination blade provided with your saw When rip cutting large sheets, the rip fence  
is for both cross cuts and rip cuts. Ripping is may not allow the desired width of cut. Clamp  
cutting lengthwise with the grain of the wood. or nail a straight piece of 1" (25 mm) lumber to  
Rip cuts are easy to do with a rip fence the sheet as a guide (Fig. 11). Use the right  
(
Fig. 10). Rip Fence is available as an side of the foot against the board guide.  
accessory (not included). To attach fence, insert  
fence through slots in foot to desired width as  
shown and secure with the wing nut (not  
included).  
FIG. 11  
RIP  
BOARD  
GUIDE  
FIG. 10  
DESIRED  
WIDTH OF  
CUT  
DESIRED  
LINE OF CUT  
RIP FENCE  
-
11-  

In addition to the user manual Skil 1677M, we also provide a support panel to help you solve your problems with Skil 1677M. If you have any questions, you can ask them in the form below. Other users viewing this website will have the opportunity to help you solve your probem with Skil 1677M. Remember that you can also share the solution. If you solved the problem yourself, please write the solution to the problem with Skil 1677M - you will surely help many users by doing so.

Have you got problems with your device? Ask a question - our users can help you

No one has added a comment for this device/ user manual.