If you found this page, you probably have a problem and you need a user manual for the device Quantum Instruments MS3580. Be sure to check that it is the user manual to exactly the device that you are looking for. In our database Quantum Instruments MS3580 it belongs to the category Scanner. A user manualQuantum Instruments MS3580 is taken from the manufacturer, a Quantum Instruments company - it is an official document, so if you have any doubts as to its contents, please contact the manufacturer of the device Quantum Instruments MS3580 directly. You can view the user manualQuantum Instruments MS3580 directly online or save and store it on your computer.

INSTALLATION  

Stand-Alone Keyboard  

1. Turn off the host device.  

2. Plug the male 10-pin RJ45 end  

of the PowerLink cable into the  

10-pin socket on the MS3580.  

3

. Connect the other end of the  

PowerLink cable to the keyboard  

port on the host device.  

4

. Plug the external power supply into  

the power jack on the PowerLink  

cable.  

Check the AC input  

requirements of the power  

supply to make sure the  

voltage matches the AC  

outlet. The outlet must be  

located near the equipment  

and be easily accessible.  

5

. Connect AC power to the transformer.  

. Turn on the host device.  

Figure 11.  

6

When the scanner first receives power, the blue LED will turn on; the  

scanner will simultaneously emit a beep and flash the white LED.  

Powering the MS3580 directly from the host device can sometimes  

cause interference with the operation of the scanner or the computer.  

Not all computers supply the same current through the keyboard port.  

For this reason, Metrologic recommends using an external power  

supply. For additional information contact a Metrologic customer  

service representative.  

Caution:  

To maintain compliance with applicable standards, all circuits connected to the scanner  

must meet the requirements for SELV (Safety Extra Low Voltage) according to EN/IEC  

60950.  

To maintain compliance with standard CSA C22.2 No. 60950/UL 60950 and norm  

EN/IEC 60950, the power source should meet applicable performance requirements for  

a limited power source.  

11  

• ← Previous
• Next page →

In addition to the user manual Quantum Instruments MS3580, we also provide a support panel to help you solve your problems with Quantum Instruments MS3580. If you have any questions, you can ask them in the form below. Other users viewing this website will have the opportunity to help you solve your probem with Quantum Instruments MS3580. Remember that you can also share the solution. If you solved the problem yourself, please write the solution to the problem with Quantum Instruments MS3580 - you will surely help many users by doing so.