Mounting the Camera (VN-C625)
Screw (M4) x 4
Screw (M3) x 2
1. LDoiossmeannthtleestchreewcsaomnethreacmamouernatimnogubntrinagckberatcket (M4,
pcs) using a driver to dismantle it.
. LDoiossmeannthtelestchreewcsoonnvtheertceornuvenrittermuonuit nmtoinungtibngrabcrakcektet
(M3, 2 pcs) using a driver to dismantle it.
mounting bracket, followed by mounting it to the housing
using the screws (M3, 2 pcs) removed in Step 2.
When mounting, pay attention to the orientation of the
converter unit as shown in the left diagram.
Main Housing Unit
. MMoouunnt tthtehceacmaemraemraoumntoinugnbtriancgkebtrdaiscmkeatntled in step 1.
to the housing. Mount it exactly to the original position.
Remove the ceiling mount cover of the camera and guide the
cables supplied with WB-1540 through the cover.
T For further details, please refer to the instruction manual of
the camera in use.
To [POWER INPUT DC 12 V]
Terminal of Ceiling Mount
. FCoolnlonwecthtethperoAcCed2u4reVsobuetlpouwttcoacbolenntoectthtehecoAnCve2r4teVr unit.
Connect to AC 24 V Output Cable
output cable of the main board on the main housing unit to
the converter unit.
APush both ends of the connector as shown in the left
diagram to remove it from the supplied converter unit.
BCut the Y terminal of the AC 24 V output cable and peel
off about 5 mm of the coating.
CPush the arrow mark using tools such as a flat-head
screwdriver to insert the coating of the AC 24 V output
cable into the connector.
AC 24 V Output Cable
DAttach the connector to the converter unit.
AC 24 V
2. Mceoiluinngt tmheouYntteormf VinNa-lCo6f2t5h.e converter unit to the
Guide the Y terminal of the converter unit through
the ceiling mount cover, followed by connecting it to
the [POWER INPUT DC 12 V] terminal of
VN-C625’s ceiling mount.
. CCoonnnneectctthoetnheecrecssaabrlyecsables supplied with the housing
(coaxial video cable, alarm signal cable, LAN cable, etc.)
to the corresponding terminals on the ceiling mount.
Interior of Housing
Connect the communication cable to the alarm terminal if
necessary. In addition, DC 12 V Power Cable is not in use
on this system. For safety reasons, ensure to cut off any
excess cable and bind using an insulating tape before use.
Camera Mounting Bracket
● For further details on connection, please refer to the
instruction manual of the camera in use.
. hMoouusnitntghuenciat.mera’s ceiling mount to the main
Use the 4 screws supplied (M4 x 20) to mount the ceiling
mount to the main housing unit.
Screws Supplied (M4 x 20) x 4
During mounting, align the [DFRONT] mark of the ceiling
mount with the notch on the camera mount bracket of the
main housing unit.
. FMoollouwntintshtreucctaiomnseirnathtoe mthaenucaeliloifntghemcoamunerta in use to
mount the camera to the ceiling mount.