User manual WatchGuard Technologies Server 700

If you found this page, you probably have a problem and you need a user manual for the device WatchGuard Technologies Server 700. Be sure to check that it is the user manual to exactly the device that you are looking for. In our database WatchGuard Technologies Server 700 it belongs to the category Server. A user manualWatchGuard Technologies Server 700 is taken from the manufacturer, a WatchGuard Technologies company - it is an official document, so if you have any doubts as to its contents, please contact the manufacturer of the device WatchGuard Technologies Server 700 directly. You can view the user manualWatchGuard Technologies Server 700 directly online or save and store it on your computer.

Installing the Firebox III  
You can connect to and initialize a new Firebox in several ways:  
Using TCP/IP. This is the quickest way to configure a Firebox in most  
situations.  
Using a serial cable. Use this method if you want to isolate the Firebox  
during configuration.  
Using a modem. Use this method if the Firebox is located remotely  
from the Management Station.  
Using remote provisioning. Use this method in the case where a  
router sits between the Management Station (the computer on which  
you install the WatchGuard Firebox System Control Center software)  
and the Firebox network connection.  
Cabling a Firebox using TCP/IP  
This process uses TCP/IP over Ethernet to connect and initialize a new  
Firebox. The Firebox will automatically obtain its IP address.  
1
Place the Firebox on a desktop or in a rack in a location convenient to  
the external router.  
2
Use the red (cross-over) cable (provided with the Firebox) to connect  
the Firebox Trusted interface to the same network as the computer  
that will act as the Firebox Management Station.  
If the Firebox is to be connected to the Firebox Management Station in isolation,  
you must use either a hub or the red cable.  
3
4
Install the power cord from the AC receptacle on the Firebox to a  
power source.  
When prompted to do so during the QuickSetup wizard (described in  
“Running the QuickSetup Wizard” on page 11), select Use TCP/IP to  
Configure as the confirmation access method.  
Cabling a Firebox for serial cable initialization  
This process requires that you manually create an IP address.  
1
2
Place the Firebox in a location convenient to the Management Station.  
Use the blue serial cable to connect the Firebox console port with the  
Management Station COM port. Use the red crossover cable to  
connect the Trusted interface to the Management Station Ethernet  
port.  
Hardware Guide  
9

In addition to the user manual WatchGuard Technologies Server 700, we also provide a support panel to help you solve your problems with WatchGuard Technologies Server 700. If you have any questions, you can ask them in the form below. Other users viewing this website will have the opportunity to help you solve your probem with WatchGuard Technologies Server 700. Remember that you can also share the solution. If you solved the problem yourself, please write the solution to the problem with WatchGuard Technologies Server 700 - you will surely help many users by doing so.

Have you got problems with your device? Ask a question - our users can help you

No one has added a comment for this device/ user manual.