User manual Kenwood KFC-W2510

If you found this page, you probably have a problem and you need a user manual for the device Kenwood KFC-W2510. Be sure to check that it is the user manual to exactly the device that you are looking for. In our database Kenwood KFC-W2510 it belongs to the category Speaker. A user manualKenwood KFC-W2510 is taken from the manufacturer, a Kenwood company - it is an official document, so if you have any doubts as to its contents, please contact the manufacturer of the device Kenwood KFC-W2510 directly. You can view the user manualKenwood KFC-W2510 directly online or save and store it on your computer.

安装  
Installation  
1
2
3
. 将建伍提供的模板放在面板上 , 然后标出孔的位置。  
. 按照标出的位置开出一个大孔 , 并且开一些用于固定扬声器的螺钉孔。  
1. Place the supplied template on the panel and then mark the hole positions.  
2. Cut open  
Peel off the covering sheet from the spacer, and attach the spacer on the back of the speaker flange so  
that the flange is completely covered.  
a large hole and make screw holes.  
3
.
.
揭开密封海绵的不干胶贴 , 将胶面粘贴在扬声器的固定边沿的背面 , 这样会使安装面同安装面板  
更好的贴合。  
图 . 1-1  
Fig. 1-1  
图 . 1-2  
Fig. 1-2  
系统连接  
System connections  
首先 , 检查功率放大器的功率。如果功率放大器的额定功率高于副低音扬声器的额定输入功率 , 请  
增加扬声器的数量或者降低功率放大器的增益 , 使输入扬声器的功率低于扬声器的额定输入功率。  
输入功率大于扬声器额定输入功率会导致扬声器发出噪音或者扬声器的损坏。同时 , 如果使用多扬  
声器连接 , 请注意扬声器的总阻抗。请根据功率放大器的阻抗来改变扬声器的连接方式。  
First, check the power of the amplifier. If the power of the amplifier is higher than the subwoofer’s rated  
input power, increase the number of subwoofers so that the power fed to each subwoofer is lower than  
its rated input power, or lower the sensitivity of the amplifier. Supplying power greater than its rated input  
power of the subwoofer will cause noise and/or breakage. Also, if using multiple subwoofers, be careful  
about the total impedance. Change the connecting pattern of the speakers according to the capable  
impedance of the amplifier.  
串联  
并联  
串联 - 并联连接  
Series Wiring  
Parallel Wiring  
Series-Parallel Wiring  
R
=
1
+ 11 + ...  
R2  
R
= R1 + R2 +  
...  
R1  
4
(ohms)  
4 (ohms)  
R1  
=
4
(ohms)  
R2  
=
4
(ohms)  
R1 = 4 (ohms)  
R2  
=
4
(ohms)  
4
(ohms)  
4 (ohms)  
R
=
4
+
4
=
8
(ohms)  
R
=
1
+
=
2
(ohms)  
R
=
1
+
+
1
+
= 4 (ohms)  
1
4
1
4
1
4
1
4
1
4
1
4
图 . 2-1  
Fig. 2-1  
图 . 2-2  
Fig. 2-2  
图 . 2-3  
Fig. 2-3  
使用分频器选择不同使用状态的使用频率  
主机  
Use a crossover network of your choice with an appropriate cut-off frequency.  
电子分频器  
Electronic crossover network  
功率放大器  
Center unit  
Power amplifier  
全频扬声器  
Full range speaker  
副低音扬声器  
Subwoofer  
KFC-W3010  
KFC-W2510  
图 . 3  
Fig. 3  
警告  
Caution  
请将功率放大器的增益调至与 CD 播放器或者调频调幅接收机的预置输出值接近  
的数值。  
The sensitivity of the power amplifier should be set to the same value as the pre-  
output volume of the CD player or Tuner.  
B61-1292-00_0_KFC-W3010_W2510.indd 4-1  
06.3.16 2:12:29 PM  

In addition to the user manual Kenwood KFC-W2510, we also provide a support panel to help you solve your problems with Kenwood KFC-W2510. If you have any questions, you can ask them in the form below. Other users viewing this website will have the opportunity to help you solve your probem with Kenwood KFC-W2510. Remember that you can also share the solution. If you solved the problem yourself, please write the solution to the problem with Kenwood KFC-W2510 - you will surely help many users by doing so.

Have you got problems with your device? Ask a question - our users can help you

No one has added a comment for this device/ user manual.