User manual Onkyo SKF-960F

If you found this page, you probably have a problem and you need a user manual for the device Onkyo SKF-960F. Be sure to check that it is the user manual to exactly the device that you are looking for. In our database Onkyo SKF-960F it belongs to the category Stereo Receiver. A user manualOnkyo SKF-960F is taken from the manufacturer, a Onkyo company - it is an official document, so if you have any doubts as to its contents, please contact the manufacturer of the device Onkyo SKF-960F directly. You can view the user manualOnkyo SKF-960F directly online or save and store it on your computer.

HT-S9100THX_En.book Page4 Friday,June27,2008 4:00PM  
Speaker Precautions  
Precautions—Continued  
For British models  
Placement  
Replacement and mounting of an AC plug on the power  
supply cord of this unit should be performed only by  
qualified service personnel.  
The speaker cabinets are made out of wood and are  
therefore sensitive to extreme temperatures and  
humidity, do not put them in locations subject to direct  
sunlight or in humid places, such as near an air condi-  
tioner, humidifier, bathroom, or kitchen.  
Do not put water or other liquids close to the speakers.  
If liquid is spilled over the speakers, the drive units  
may be damaged.  
IMPORTANT  
The wires in the mains lead are coloured in accordance  
with the following code:  
Blue:  
Neutral  
Brown: Live  
As the colours of the wires in the mains lead of this  
apparatus may not correspond with the coloured mark-  
ings identifying the terminals in your plug, proceed as  
follows:  
• Speakers should only be placed on sturdy, flat surfaces  
that are free from vibration. Putting them on uneven or  
unstable surfaces, where they may fall and cause dam-  
age, will affect the sound quality.  
The wire which is coloured blue must be connected to  
the terminal which is marked with the letter N or  
coloured black.  
The wire which is coloured brown must be connected to  
the terminal which is marked with the letter L or  
coloured red.  
• The subwoofer should be used in the upright position  
only. Do not use it on its side or at an angle.  
• If the speakers are used near a turntable, CD player, or  
DVD player, howling or disc skipping may occur. To  
prevent this, move the speakers away from the turnta-  
ble or player, or turn down the volume.  
IMPORTANT  
Using Close to a TV or Computer  
The plug is fitted with an appropriate fuse. If the fuse  
needs to be replaced, the replacement fuse must be  
approved by ASTA or BSI to BS1362 and have the same  
ampere rating as that indicated on the plug. Check for  
the ASTA mark or the BSI mark on the body of the fuse.  
If the power cord’s plug is not suitable for your socket  
outlets, cut it off and fit a suitable plug. Fit a suitable  
fuse in the plug.  
TVs and computer monitors are magnetically sensitive  
devices and as such are likely to suffer discoloration or  
picture distortion when conventional speakers are  
placed nearby. To prevent this, the SKF-960F and  
SKC-960C feature internal magnetic shielding. In some  
situations, however, discoloration may still be an issue,  
in which case you should turn off your TV or monitor,  
wait 15 to 30 minutes, and then turn it back on again.  
This normally activates the degaussing function, which  
neutralizes the magnetic field, thereby removing any  
discoloration effects. If discoloration problems persist,  
try moving the speakers away from your TV or monitor.  
Note that discoloration can also be caused by a magnet  
or demagnetizing tool that’s too close to your TV or  
monitor.  
For European Models  
Declaration of Conformity  
We, ONKYO EUROPE  
ELECTRONICS GmbH  
LIEGNITZERSTRASSE 6,  
8
2194 GROEBENZELL,  
GERMANY  
Input Signal Warning  
declare in own responsibility, that the ONKYO product  
described in this instruction manual is in compliance with the  
corresponding  
technical standards such as EN60065,  
The speakers can handle the specified input power when  
used for normal music reproduction. If any of the fol-  
lowing signals are fed to them, even if the input power is  
within the specified rating, excessive current may flow  
in the speaker coils, causing burning or wire breakage:  
EN55013, EN55020 and EN61000-3-2, -3-3.  
GROEBENZELL, GERMANY  
K. MIYAGI  
ONKYO EUROPE ELECTRONICS GmbH  
1
2
3
. Interstation noise from an untuned FM radio.  
. Sound from fast-forwarding a cassette tape.  
. High-pitched sounds generated by an oscillator,  
electronic musical instrument, and so on.  
. Amplifier oscillation.  
4
5
6
. Special test tones from audio test CDs and so on.  
. Thumps and clicks caused by connecting or discon-  
necting audio cables (Always turn off your amplifier  
before connecting or disconnecting cables.)  
. Microphone feedback.  
7
4

In addition to the user manual Onkyo SKF-960F, we also provide a support panel to help you solve your problems with Onkyo SKF-960F. If you have any questions, you can ask them in the form below. Other users viewing this website will have the opportunity to help you solve your probem with Onkyo SKF-960F. Remember that you can also share the solution. If you solved the problem yourself, please write the solution to the problem with Onkyo SKF-960F - you will surely help many users by doing so.

Have you got problems with your device? Ask a question - our users can help you

No one has added a comment for this device/ user manual.