User manual Nady Systems GEQ 231

If you found this page, you probably have a problem and you need a user manual for the device Nady Systems GEQ 231. Be sure to check that it is the user manual to exactly the device that you are looking for. In our database Nady Systems GEQ 231 it belongs to the category Stereo Equalizer. A user manualNady Systems GEQ 231 is taken from the manufacturer, a Nady Systems company - it is an official document, so if you have any doubts as to its contents, please contact the manufacturer of the device Nady Systems GEQ 231 directly. You can view the user manualNady Systems GEQ 231 directly online or save and store it on your computer.

REAR PANEL CONTROLS AND CONNECTIONS  
9
10  
GEQ 131/131LF  
Single Channel 31 Band Graphic Equalizers  
11  
12  
13  
9
10  
1
1
12  
10  
13  
9
GEQ 215/215LF  
2
Channel 15 Band Graphic Equalizers  
11  
12  
13  
13  
9
10  
11  
12  
13  
13  
GEQ 231  
9
10  
2
Channel 31 Band Graphic Equalizer  
11  
12  
9.  
IEC Power Cord Receptacle  
13  
This is used to connect the AC power source to your equalizer.  
Power requirements: 115/230VAC, 50/60Hz  
13. Input/Output Connectors  
See INPUT/OUTPUT CONNECTIONS section (page 2) for  
proper wiring of the XLR, 1/4" TRS and RCA connectors for  
desired active balanced or unbalanced operation.  
10. AC Voltage Selector  
Set this slide switch to match your line voltage supply.  
Paralleling inputs and outputs may be accomplished by using any  
of the 3 connectors. Note: The 1/4" TRS connectors are normally  
used for this function.  
Note: while you can use any input connector with any output con-  
nector, only one of these connectors is to be used at a time.  
CAUTION: For new installations and portable sound systems, or  
in any situation in which the AC power is suspect, it is wise to  
confirm appropriate voltage and line polarity BEFORE connecting  
the instrument to the power source.  
11. Fuse Holder  
This fuse holder contains an AC primary fuse. This fuse should  
be replaced with the same type fuse when this is blown out. If  
they continuously blow, stop replacing the fuse and refer  
servicing to qualified personnel.  
CAUTION: After checking the AC supply voltage, be sure that  
the correct fuse is in the fuse holder: 0.5 Amp for 100-130VAC  
and for 220-240V AC.  
12. Ground-Lift Switch  
This switch is used to disconnect the signal ground from the AC  
power and chassis earth ground. This switch should be put in the  
LIFT position if the speakers produce humming sounds caused  
by a ground loop.  
7

In addition to the user manual Nady Systems GEQ 231, we also provide a support panel to help you solve your problems with Nady Systems GEQ 231. If you have any questions, you can ask them in the form below. Other users viewing this website will have the opportunity to help you solve your probem with Nady Systems GEQ 231. Remember that you can also share the solution. If you solved the problem yourself, please write the solution to the problem with Nady Systems GEQ 231 - you will surely help many users by doing so.

Have you got problems with your device? Ask a question - our users can help you

No one has added a comment for this device/ user manual.