User manual Audiovox TERK SIR4

If you found this page, you probably have a problem and you need a user manual for the device Audiovox TERK SIR4. Be sure to check that it is the user manual to exactly the device that you are looking for. In our database Audiovox TERK SIR4 it belongs to the category Stereo System. A user manualAudiovox TERK SIR4 is taken from the manufacturer, a Audiovox company - it is an official document, so if you have any doubts as to its contents, please contact the manufacturer of the device Audiovox TERK SIR4 directly. You can view the user manualAudiovox TERK SIR4 directly online or save and store it on your computer.

Air Dam Shield Mount Installation Continued  
10. Install antenna to Air Dam Shield of truck, See Figure 8.  
1
1. Loosen two screws and two hex nuts in U-Bracket assembly. Note: Installation on tubular sur-  
face is NOT recommended. Insert Air Dam Shield edge between the U-Bracket Assembly and  
Clamp feet. See Figure 9.  
12. Tighten clamp screws on U-Bracket Assembly evenly up against the Air Dam Shield to  
15 ft-lbs. using the appropriate torque wrench and adapters (1/2” size, hex or open-end  
wrench). IMPORTANT: Assure two 5/16” Hex Nuts are not tight at this step.  
13. Tighten two 5/16”-18 Hex Nuts securely up against clamp bracket, See Figure 9.  
14. Using the appropriate torque wrench and adapters (1/2” size, hex or open-end wrench) torque  
5
/16-18 Hex Nuts to 4 ft-lbs. (48 in-lbs.).  
5. Loosen the 3/8”-16 Hex Nut and pivot antenna until true vertical position is achieved. Re-torque  
/8”-16 Hex Nuts to 12 ft-lbs.  
1
1
1
1
1
3
6. Take the cable connector (180 degree connector) NOT the Right-Angle SMB Connector and  
hand tighten over the connector on the bottom side of the Antenna Assembly. See Figure 10.  
7. Using the 5/16” open-end wrench, tighten the cable connector on the Antenna Assembly  
connector.  
8. Place the rubber boot over the end of the Antenna Assembly shaft after the cable connector has  
been tighten. See Figure 10  
9. Route cable into truck cab and connect to satellite receiver. Verify you have satellite broadcast.  
Figure 8. Mounting Location  
Figure 9. Mounting Location  
Figure 10. Cable Connector/  
Rubber Boot Connection  
10  

In addition to the user manual Audiovox TERK SIR4, we also provide a support panel to help you solve your problems with Audiovox TERK SIR4. If you have any questions, you can ask them in the form below. Other users viewing this website will have the opportunity to help you solve your probem with Audiovox TERK SIR4. Remember that you can also share the solution. If you solved the problem yourself, please write the solution to the problem with Audiovox TERK SIR4 - you will surely help many users by doing so.

Have you got problems with your device? Ask a question - our users can help you

No one has added a comment for this device/ user manual.