User manual Allied Telesis Switch X900-24XS

If you found this page, you probably have a problem and you need a user manual for the device Allied Telesis Switch X900-24XS. Be sure to check that it is the user manual to exactly the device that you are looking for. In our database Allied Telesis Switch X900-24XS it belongs to the category Switch. A user manualAllied Telesis Switch X900-24XS is taken from the manufacturer, a Allied Telesis company - it is an official document, so if you have any doubts as to its contents, please contact the manufacturer of the device Allied Telesis Switch X900-24XS directly. You can view the user manualAllied Telesis Switch X900-24XS directly online or save and store it on your computer.

Installation and Safety Guide  
Connecting to the Switch  
All x900 Series switches and the SwitchBlade x908 can be configured using the  
Command Line Interface (CLI) and the Graphical User Interface (GUI).  
The procedure and command syntax varies depending on whether the switch is  
®
running the AlliedWare operating system or the AlliedWare Plus™ operating  
system.  
Before configuring the switch, you must make some basic connections explained  
in the following procedures:  
“Using the AlliedWare Plus Operating System CLI” on page 17  
“Using the AlliedWare Plus Operating System GUI” on page 20  
“Using the AlliedWare Operating System CLI” on page 22  
“Using the AlliedWare Operating System GUI” on page 24  
Before starting these procedures, ensure that the switch is connected to a  
power supply and receiving power.  
Using the AlliedWare Plus Operating System CLI  
Depending on the model, an ASYN0/CONSOLE and/or ETH0 port is on the  
front of the switch for installation and maintenance.  
Note that AlliedWare Plus does not have a default IP address configured on the  
ETH0 port. If you want to connect via the ETH0 port using Telnet on your PC  
you must connect via the ASYN0/CONSOLE port to configure an IP address on  
the ETH0 port before you connect to the ETH0 port to use Telnet on your PC.  
1
. To use the ETH0 port, you must first assign an IP address to the port.  
Log in via the ASYN0/CONSOLE port as described in steps 2 and 3 below,  
then enter the following commands:  
awplus>enable  
awplus#configure terminal  
awplus(config)#interface eth0  
awplus(config-if)#ip address <address/mask>  
where <address/mask> is an IP address and mask in slash notation, for  
example 192.168.242.242/24.  
Physically connect the ETH0 port to a terminal or PC, and check that the  
port’s LEDs are lit. This means a link has been established between the port  
and the PC. For NEBS compatibility, the cable must be shielded and  
grounded at both ends, especially if permanently connected.  
1
7

In addition to the user manual Allied Telesis Switch X900-24XS, we also provide a support panel to help you solve your problems with Allied Telesis Switch X900-24XS. If you have any questions, you can ask them in the form below. Other users viewing this website will have the opportunity to help you solve your probem with Allied Telesis Switch X900-24XS. Remember that you can also share the solution. If you solved the problem yourself, please write the solution to the problem with Allied Telesis Switch X900-24XS - you will surely help many users by doing so.

Have you got problems with your device? Ask a question - our users can help you

No one has added a comment for this device/ user manual.