Bedienungsanleitung Quantum Instruments MS3580

Wenn Sie auf diese Seite gestoßen sind, dann haben Sie bestimmt ein Problem und benötigen eine Anleitung zum Gerät Quantum Instruments MS3580. Denken Sie daran zu prüfen, ob es eine Anleitung zu genau diesem Gerät ist, was Sie suchen. In unserer Datenbank gehört Quantum Instruments MS3580 zu der Kategorie Scanner. Die Anleitung Quantum Instruments MS3580kommt vom Produzenten, der Firma Quantum Instruments - es ist ein offizielles Dokument, und wenn Sie irgendwelche Zweifel haben, was den Inhalt betrifft, kontaktieren Sie bitte den Geräteproduzenten Quantum Instruments MS3580 direkt. Sie können die Anleitung Quantum Instruments MS3580 direkt online anschauen, oder es auf Ihrem Computer speichern und aufbewahren.

INSTALLATION  
RS232, RS232 TTL, Light Pen or Laser Emulation  
1. Turn off the host device.  
2. Plug the male 10-pin RJ45 end  
of the PowerLink cable into the  
10-pin socket on the MS3580.  
3. Connect the 9-pin female end of the  
PowerLink cable to the host device.  
4. Plug the external power supply into the  
power jack on the PowerLink cable.  
Check the AC input requirements  
of the power supply to make sure  
the voltage matches the AC outlet.  
The outlet must be located near  
the equipment and be easily  
accessible.  
5
. Connect AC power to the transformer.  
. Turn on the host device.  
6
Figure 8.  
When the scanner first receives power, the blue LED will turn on; the  
scanner will simultaneously emit a beep and flash the white LED.  
Plugging the scanner into the serial port of the PC does not guarantee  
that scanned information will appear at the PC. A software driver and  
correct configuration setting are also required for proper  
communication to occur.  
The MS3580-104 leaves the factory with the Laser Emulation  
enabled. If the Recall Defaults bar code is scanned while  
reconfiguring the scanner, laser emulation will no longer be enabled.  
Scan the Laser Emulation barcode in Section J: Laser Emulation of  
the MetroSelect Configuration Guide to re-enable the laser emulation  
interface. This feature is only supported for MS3580-104 models.  
Caution  
To maintain compliance with applicable standards, all circuits connected to the scanner  
must meet the requirements for SELV (Safety Extra Low Voltage) according to EN/IEC  
60950.  
To maintain compliance with standard CSA C22.2 No. 60950/UL 60950 and norm  
EN/IEC 60950, the power source should meet applicable performance requirements for  
a limited power source.  
8

Außer der Anleitung Quantum Instruments MS3580, veröffentlichen wir ebenfalls das Hilfspaneel, das Ihnen bei der Lösung der Probleme mit Quantum Instruments MS3580 helfen wird. Wenn Sie Fragen haben, können Sie sie im unten angegebenem Formular stellen. Andere Nutzer, die hier reinschauen, werden dann die Möglichkeit haben, Ihnen bei der Lösung des Problems mit Quantum Instruments MS3580 zu helfen. Denken Sie daran, dass Sie auch die Lösung mit anderen Teilen können. Wenn Sie es selbst geschafft haben, fügen Sie bitte hier die Beschreibung und die Lösung des Problems mit Quantum Instruments MS3580 hinzu - damit helfen Sie bestimmt vielen Nutzern.

Probleme mit dem Gerät? Stellen Sie Fragen - unsere Nutzer können helfen

Es wurde noch kein Kommentar zu diesem Gerät/ dieser Anleitung hinzugefügt.