30STU.fm Page 7 Thursday, March 18, 2010 1:48 PM
press any buttons on the TV or remote while
If a message appears for you to confirm the
Press F/fto select the country/region in
which you will operate the TV, then press
No digital or analogue channels were found.
Check all the aerial/cable connections and press
to start auto-tuning again.
Programme Sorting (Only in analogue
mode): Changes the order in which the
analogue channels are stored on the TV.
Press F/fto select the channel you want to
move to a new position, then press g.
Press F/fto select the new position for your
If the country/region which you want to use on
the TV does not appear in the list, select “-”
instead of a country/region.
channel, then press
If you do not change the order in which the
analogue channels are stored on the TV, press
HOME to go to next step.
Press F/fto select the location type in
This step will not appear if any analogue channel is
which you will operate the TV, then
The message "Set-up complete" will appear on
the screen. Press
The TV has now tuned in all the available
You can update the TV system using USB memory.
Obtain information from the website below.
To tune the TV for Cable connection
In Shop mode, some settings will be periodically
reset for Shop usage.
This option selects the initial picture mode
appropriate for the typical lighting condition in
Press F/fto select “Quick Scan” or “Full
Scan”, then press
"Quick Scan" : channels are tuned according to
the cable operator information within the
Recommended setting for "Frequency" and
: Auto-tuning the TV
This option is recommended for fast tuning when
supported by your cable operator.
Network ID" is "Auto".
If the "Quick Scan" does not tune, please use the
Full Scan" method below.
Full Scan" : All available channels are tuned
and stored. This procedure may take some time.
This option is recommended when "Quick Scan"
is not supported by your cable provider.
For further information about supported cable
providers, refer to support web site:
Press G/g/fto select “Start”.
The TV starts searching for channels. Do not
press any buttons on the TV or remote.
Press F/fto select “Antenna” or “Cable”,
then press .
If you select “Cable”, the screen for selecting the
scan type appears. See “z” (page 7).
The TV starts searching for all available digital
channels, followed by all available analogue
channels. This may take some time, so do not
Some cable providers do not support “Quick Scan”. If no
channels are detected using “Quick Scan”, perform “Full
KDL-40/32P36xx KDL-40/37/32P56xx KDL-40/37/32S56xx