Manuel d'utilisation Whirlpool GXW6530DXS

Si vous arrivez à cette page, vous avez probablement un problème, et vous avez besoin de manuel du dispositif Whirlpool GXW6530DXS. Soyez sûr de vérifier qu'il s'agit exactement de manuel du dispositif que vous cherchez. Dans notre base de données Whirlpool GXW6530DXS il appartient à la catégoriePortée. Le manuel d'utilisation Whirlpool GXW6530DXS vient du fabricant, l'entreprise Whirlpool - c'est un document officiel, et si vous avez des doutes quant à son contenu, s'il vous plaît contacter directement le fabricant Whirlpool GXW6530DXS. Le manuel Whirlpool GXW6530DXS peut être visualisé directement en ligne, ou enregistré et stocké sur votre ordinateur.

INSTALLATION INSTRUCTIONS  
PrepareLocation  
8. Mark centers of the fastener locations through the template  
to the wall.  
It is recommended that the vent system be installed before  
hood is installed.  
IMPORTANT: All screws must be installed into wood. If there  
is no wood to screw into, additional wall framing supports  
may be required.  
Before making cutouts, make sure there is proper clearance  
within the ceiling or wall for exhaust vent.  
Check your ceiling height and the hood height maximum  
before you select your hood.  
Remove the template.  
9
.
Drill ³⁄₁₆" (4.8 mm) pilot holes at all locations where screws are  
being installed into wood.  
1
.
Disconnect power.  
2.  
Determine which venting method to use: roof, wall, or non-  
vented.  
1
0. Install the 2 - 5 x 45 mm mounting screws. Leave a  
⁄₄" (6.4 mm) gap between the wall and the back of the  
screw head to slide range hood into place.  
¹
3.  
Select a flat surface for assembling the range hood. Place  
covering over that surface.  
¹
⁄₄"  
(6.4 mm)  
WARNING  
Excessive Weight Hazard  
Use two or more people to move and install  
range hood.  
Vent Cover Bracket Installation  
Failure to do so can result in back or other injury.  
1
1. Attach vent cover bracket to wall flush to the ceiling using  
2
- 5 x 45 mm screws.  
4.  
Using 2 or more people, lift range hood onto covered surface.  
Range Hood Mounting Screws Installation  
5
.
.
Determine and mark the centerline on the wall where the  
canopy hood will be installed.  
A
6
Select a mounting height between a minimum of  
24" (61.0 cm) for an electric cooking surface, a minimum  
B
of 27" (68.6 cm) for a gas cooking surface, and a suggested  
maximum of 36" (91.4 cm) above the range to the bottom  
of the hood. Mark a reference line on the wall.  
7.  
Tape template in place, aligning the template centerline and  
bottom of template with hood bottom line and with the  
centerline marked on the wall.  
C
A
A. Ceiling  
B. Wall  
DRILL2(TWO)3/16"PILOTHOLESTHROUGHSTUDSORREARWALLSUPPORT  
C. Centerline  
REARWALL  
MOUNTINGTEMPLATE  
Complete Preparation  
CL  
ALIGNBOTTOM EDGE  
WITHPENCILLINE  
INDICATINGBOTTOM  
OFTHEHOOD  
1. Determine and make all necessary cuts in the wall for the vent  
system. Install the vent system before installing the hood. See  
InstallationHeight  
HorizontalLine  
“Venting Requirements” section.  
2.  
Determine the required height for the home power supply  
cable and drill a 1¼" (3.2 cm) hole at this location.  
B
C
A. Centerline  
B. Fastener locations  
C. Mounting height reference  
hood bottom line)  
3. Run the home power supply cable according to the National  
Electrical Code or CSA Standards and local codes and  
ordinances. There must be enough ½" conduit and wires from  
the fused disconnect (or circuit breaker) box to make the  
connection in the hood’s electrical terminal box.  
(
NOTE: Do not reconnect power until installation is complete.  
4. Use caulk to seal all openings.  
7

En plus du manuel Whirlpool GXW6530DXS, nous fournissons également des panneaux d'assistance qui vous aideront à résoudre vos problèmes avec Whirlpool GXW6530DXS. Si vous avez des questions, vous pouvez les poser dans le formulaire ci-dessous. Les autres utilisateurs qui viennent ici, auront l'occasion de vous aider à résoudre votre problèmeWhirlpool GXW6530DXS.

Problème avec le dispositif? Posez une question, nos utilisateurs peuvent aider

Personne n'a ajouté commentaire pour ce dispositif/manuel.