Handleiding QSC Audio I-YM8

Als u deze pagina heeft gevonden, heeft u waarschijnlijk een probleem en heeft u waarschaijnelijk de danleiding voor het apparaat QSC Audio I-YM8 nodig. Controleer dat het een handleiding is voor het apparaat dat u zoekt. In onze databank QSC Audio I-YM8 behoort het tot de categorie Luidspreker. De handleiding QSC Audio I-YM8 is afkomstig van de fabrikant, het bedrijf QSC Audio - het is een officieel document, en als u twijfelt over de inhoud, neem dan direct contact op met de fabrikant van het apparaat QSC Audio I-YM8. De handleiding QSC Audio I-YM8 kunt u direct online bekijken of op te slaan op uw computer.

Painting the I-82H Loudspeaker  
The loudspeaker enclosure, grill, and mount can be painted to match any decor, provided the following precautions are observed.  
The cabinet is made of high impact polystyrene which requires controlled painting procedures in order to obtain good results. Use a  
paint “system” designed for high impact polystyrene from any reputable paint supplier.  
1
2
3
4
- Remove the grill.  
- If painting mount and loudspeaker as a unit: Attach the I-YM8.  
- Mask the loudspeaker’s input connector.  
- Mask the woofer, tweeter, and port being certain not to apply tape directly to the drivers. Alternatively, the inside of the grill can  
be completely masked and set in place on the loudspeaker enclosure for painting.  
- Wash the components to be painted with a mild soap and hot water. Be careful not to get water on or into either of the drivers or  
the input connections. Rinse with hot water. Allow to dry thoroughly.  
5
6
7
8
9
1
1
1
1
- Scuff-sand the components to be painted using red Scotchbrite® pad or 320 - 400 grit sandpaper.  
- Using compressed air, remove all dust from the components to be painted. Do not blow compressed air directly into either driver.  
- Clean the components to be painted.  
- Using a clean, lint-free, white cloth, wipe the components to be painted with suitable prep solution.  
0- Apply adhesion promoter.  
1- Apply primer topcoat.  
2- Apply paint.  
EN  
3- Allow to dry for at least 8 hours before handling.  
1
0

Naast de handleiding QSC Audio I-YM8, bieden wij ook hulp panel die u zal helpen om uw problemen op te lossen met QSC Audio I-YM8. Als u vragen heeft, kunt u ze in het onderstaande formulier invullen. Andere gebruikers zullen ze zien en kunnen u helpen om uw probleem op te lossen met QSC Audio I-YM8. Vergeet niet dat u ook de oplossing kunt delen. Als u uzelf het probleem heeft opgelost, plaats hier een beschrijving en uw oplossing met QSC Audio I-YM8 - u zal zeker de vele gebruikers helpen

Problemen met het apparaat? Stel een vraag - onze gebruikers kunnen helpen

Nog niemand heeft een commentaar voor deze machin/handleiding toegevoegd.