Lit. #: 91-0222/03-01
2-36 x 50mm Vari-Power
Remove the spotting scope and tripod from the box. Screw
the tripod attachment screw into the tripod boss on the
spotting scope. Spread the tripod legs and set on a solid
Model # 78-1236
The spotting scope is focused with the focus ring. The tube
with the vari-power ring and the eyepiece will move “in” and
the tube is all the way “out,” the spotting scope is at its
closest focus position.
out” depending on the direction the ring is turned. When
Never disassemble your spotting scope or tripod. Special tools
and equipment are required for service and irreparable
damage can result from untrained attempted service.
Unauthorized service may also void the Warranty.
The magnification is changed by rotating the vari-power ring.
It will be necessary to re-focus when the magnification is
The spotting scope is positioned, on the tripod with the
elevation and horizontal control. To adjust where the scope
is pointing, rotate the handle counter clockwise. To lock,
rotate the handle clockwise.
SPOTTING SCOPE LIFETIME LIMITED WARRANTY
Your spotting scope is warranted to be free of defects in materials and
workmanship for the lifetime of the original owner. The Lifetime Limited
Warranty is an expression of our confidence in the materials and mechanical
Remove the dust caps. Point the spotting scope as desired –
as described in section 2.
workmanship of our products and is your assurance of
a lifetime of
dependable service. In the event of a defect under this warranty, we will, at
our option, repair or replace the product, provided that you return the
product postage prepaid. This warranty does not cover damages caused by
misuse or improper handling, installation or maintenance of the product.
CAUTION: DO NOT LOOK AT THE SUN THROUGH THIS
SPOTTING SCOPE AS SEVERE EYE DAMAGE MAY RESULT.
Any return made under this warranty
must be accompanied by the items listed below:
Set the vari-power ring at the lowest power (20x). Focus the
spotting scope as described in section 2. Increase the power,
and re-focus. Please note, however, that at the highest
powers the image may not appear sharp, because of several
causes. First, the image will become less bright, second, all
disturbances and contaminations in the air will be
emphasized, and last, all motion and vibration of the spotting
scope and support will also be magnified.
1)A check in the amount of $10.00 to cover the cost of handling
2)Name and address for product return
)An explanation of the defect
)Product should be well packed in a sturdy outside shipping carton to
prevent damage in transit and return postage prepaid to the
address listed below:
IN U.S.A. Send To:
IN CANADA Send To:
Bushnell Performance Optics
8500 Marshall Drive
Lenexa, Kansas 66214
Bushnell Performance Optics
25A East Pearce Street, Unit 1
Richmond Hill, Ontario L4B 2M9
The lenses of your spotting scope are 100% hard magnesium
fluoride coated for highest light transmission. As with any
optical coating, special care must be taken in cleaning the
lenses. A Lens Cleaning Kit is recommended. Moisten surface
of lens slightly and wipe dry using a circular motion starting
at center of lens. Wipe or brush off any dirt or dust on the
outside of spotting scope and tripod.
For products purchased outside the United States and Canada please contact
your local dealer for applicable warranty information. This warranty gives you
specific legal rights. You may have other rights which vary from country
2001 Bushnell Performance Optics