User manual Crimestopper Security Products SV-9155

If you found this page, you probably have a problem and you need a user manual for the device Crimestopper Security Products SV-9155. Be sure to check that it is the user manual to exactly the device that you are looking for. In our database Crimestopper Security Products SV-9155 it belongs to the category Automobile Electronics. A user manualCrimestopper Security Products SV-9155 is taken from the manufacturer, a Crimestopper Security Products company - it is an official document, so if you have any doubts as to its contents, please contact the manufacturer of the device Crimestopper Security Products SV-9155 directly. You can view the user manualCrimestopper Security Products SV-9155 directly online or save and store it on your computer.

WIRING:  
1
. Choose a convenient place to run the cable either down the left side or right side A-Pillar of the  
vehicle. (The left side is usually the easier side)  
2
3
. Remove the trim panel from the A-Pillar and route the cable down the pillar to the dash board.  
. In most vehicles, there will be a wire harness for the dome light inside the A-Pillar of the vehicle.  
Use a wire tie or electrical tape to secure the cable to this wire harness.  
. Re-Install the trim panel. Make sure that the cable does not interfere with the mounting clips or  
screws of the trim panel. This may cause damage to the cable and the trim panel and may cause  
the trim panel to not fit back into position properly.  
4
5
. Connect the RED wire to a +12V or +24V DC Ignition power terminal which is energized when the  
key is turned to the Ignition or “On” position.  
6
7
8
. Connect the GREEN trigger wire to the +12V or +24V Reverse Light wire.  
. Connect the BLACK wire to a suitable Ground on the vehicle.  
. Connect the Grey (V1) connector to the video output of the reverse camera. V1 is the priority  
input and will always auto switch when the vehicle is shifted into reverse.  
. Connect the Grey (V2) connector to the video output of any external video device (DVD, VCR,  
etc)  
9
VEHICLE IGNITION  
GREEN  
+
12V Reverse  
Light  
RED  
12V Switched IGN On  
+
VEHICLE REVERSE LIGHT  
SV-9155 MIRROR  
BLACK  
10' LENGTH  
CABLE  
Chassis Ground  
VIDEO ADAPTER PLUG  
CAM 1  
Audio Inputs (NOT USED)  
V1 Reverse Image Input  
Connect to Reverse  
Camera  
V2 Normal Image Input  
Connect to External Video Source  
Camera  
Power Plug  
YELLOW  
RCA Video Output  
CAM 2  
REVERSE CAMERA  
NOTE  
·
·
Before making any power connections to the vehicle, disconnect the Ground terminal of the  
vehicle battery to avoid any short circuits  
All plugs should be fully inserted into the connectors and secured tightly with electrical tape to  
assure the best connection. A loose connection may cause malfunctioning of the unit  

In addition to the user manual Crimestopper Security Products SV-9155, we also provide a support panel to help you solve your problems with Crimestopper Security Products SV-9155. If you have any questions, you can ask them in the form below. Other users viewing this website will have the opportunity to help you solve your probem with Crimestopper Security Products SV-9155. Remember that you can also share the solution. If you solved the problem yourself, please write the solution to the problem with Crimestopper Security Products SV-9155 - you will surely help many users by doing so.

Have you got problems with your device? Ask a question - our users can help you

No one has added a comment for this device/ user manual.