Scrolling: This function removes after-images on the
screen by moving all the pixels on the PDP according
to a pattern. Use this function when there are remaining
after-images or symbols on the screen, especially when
you displayed a still image on the screen for a long time.
Using Your TV as a Computer (PC) Display
Setting Up Your PC Software (Based on Windows XP)
Depending on the version ofWindows and the video card,
the actual screens on your PC will probably look different, but
the same basic set-up information will apply in most cases.
The after-image removal function has to be
executed for a long time (approximately 1 hour)
to effectively remove after-images on the screen.
Ifthe after-image is not removed after performing
the function, repeat the function again.
Ifnot, contact your computer manufacturer or Samsung
Click on “Control Panel” on the Windows start menu.
2. Click on “Appearance and Themes” in the “Control
Panel” window and a display dialog-box will appear.
Press any key on the remote control to cancel this
3. Click on “Display” and a display dialog box will appear.
4. Navigate to the “Settings” tab on the display dialog-box.
Side Gray (Light / Dark): When you watch TV with the
screen ratio set to 4:3, the screen is prevented from any
damage by adjusting the white balance on both extreme
left and right sides.
The correct size setting (resolution) [Optimum: 1920 X
Ifa vertical-frequency option exists on your display
settings dialog box, the correct value is ‘60’ or ‘60 Hz’.
Otherwise, just click ‘OK’ and exit the dialog box.
Picture Reset (OK / Cancel)
Resets your current picture mode to its default settings.
Setting up the TV with Your PC
Changing the Preset Sound Mode
Set the input source to PC.
MENUm → Picture → ENTERE
MENUm → Sound → SRS TheaterSound →
Auto Adjustment t
SRS TheaterSound t
Adjust frequency values/positions and ꢀne tune the settings
Standard: Selects the normal sound mode.
Music: Emphasizes music over voices.
Not available when connecting with an HDMI/DVI cable.
Movie: Provides the best sound for movies.
Clear Voice: Emphasizes voices over other sounds.
Amplify: Increase the intensity ofhigh-frequency sound
to allow a better listening experience for the hearing
Coarse / Fine: Removes or reduces picture noise. Ifthe
noise is not removed by Fine-tuning alone, then adjust
the frequency as best as possible (Coarse) and Fine-
tune again. After the noise has been reduced, readjust
the picture so that it is aligned to the center ofscreen.
Adjusting Sound Settings
Position: Adjust the PC’s screen positioning ifit does
not ꢀt the TV screen. Press the ▲ or ▼ button to adjust
the Vertical-Position. Press the ◄ or ► button to adjust
MENUm → Sound → Equalizer → ENTERE
Image Reset: Resets the image to default settings.
Adjusts the sound mode (standard sound mode only).
Balance L/R: Adjusts the balance between the right and
100Hz / 300Hz / 1kHz / 3kHz / 10kHz (Bandwidth
Adjustment): Adjusts the level ofspeciꢀc bandwidth
Reset: Resets the equalizer to its default settings.
2010-06-24 오후 4:48:23