User manual Sony CFM-10

If you found this page, you probably have a problem and you need a user manual for the device Sony CFM-10. Be sure to check that it is the user manual to exactly the device that you are looking for. In our database Sony CFM-10 it belongs to the category MP3 Player. A user manualSony CFM-10 is taken from the manufacturer, a Sony company - it is an official document, so if you have any doubts as to its contents, please contact the manufacturer of the device Sony CFM-10 directly. You can view the user manualSony CFM-10 directly online or save and store it on your computer.

Pre ca u t io n s  
Tro u b le sh o o t in g Gu id e  
No t e s o n p o w e r so u rce s  
Th e p la ye r d o e s n o t o p e ra t e .  
For AC operation, use the supplied AC power cord; do not use  
any other type (for Australian models only).  
For battery operation, use four size D (R20) batteries.  
When the batteries are not to be used for a long time, remove  
them to avoid damage that can be caused by battery leakage or  
No batteries are in the battery compartment.  
Batteries are installed incorrectly (wrong orientation).  
Weak battery. Replace all batteries.  
The AC power cord is not connected.  
No ise is h e a rd .  
Ra d io Ca sse t t e -Co rd e r  
The player is not disconnected from the AC power source (mains)  
as long as it is connected to the mains, even if the player itself has  
been turned off.  
Someone is using a portable telephone or other equipment that  
emits radio waves near the player. Move the portable telephone,  
etc., away from the player.  
Unplug the player from the wall outlet when it is not to be used  
for an extended time.  
The nameplate indicating operating voltage, power consumption,  
etc. is located at the bottom.  
Operating Instructions  
Ca sse t t e ca n n o t b e in st a lle d .  
Cassette is being inserted improperly.  
9PLAY is depressed.  
Ha n d lin g t h e p la ye r  
rREC ca n n o t b e d e p re sse d .  
Do not leave the player in a location near heat sources, or in a  
place subject to direct sunlight, excessive dust or mechanical  
No cassette.  
The cassette inserted has its tab removed. Use another cassette or  
cover the slot with adhesive tape.  
Should any solid object or liquid fall into the player, unplug the  
player and have it checked by qualified personnel before  
operating it any further.  
Ta p e d o e s n o t m o ve .  
PPAUSE is depressed.  
Weak battery. Replace all batteries.  
Do not lift the handle when the telescopic antenna is extended.  
If the player has not been used for a long time, set it in the  
playback mode to warm it up for a few minutes before inserting a  
No so u n d fro m t h e sp e a ke rs.  
The VOLUME control is turned down completely.  
The FUNCTION selector is set incorrectly.  
An earphone is plugged in (for Australian models only).  
No t e o n ca sse t t e  
The use of a cassette with more than 90 minutes of play time is not  
recommended except for long, continuous recording or playback.  
So u n d d ro p -o u t s, lo ss o f h ig h fre q u e n cie s, o r e xce ssive  
n o ise .  
If you have any questions or problems concerning your player,  
please consult your nearest Sony dealer.  
Dirty heads.  
Demagnetize the heads and all metal parts in the tape path with a  
commercially available head demagnetizer.  
Sony Corporation © 1995 Printed in China  
Before operating the player, please read this manual thoroughly and  
retain it for future reference.  
Sp e cifica t io n s  
Frequency range  
FM: 87.6-108 MHz  
AM: 530-1,710 kHz  
FM: Telescopic antenna  
AM: Built-in ferrite bar antenna  
2-track, mono  
100-8,000 Hz  
Full range: 7.7 cm (3 / 8 inches) dia. x 1  
0.9 W (at 10% harmonic distortion in DC operation)  
Earphone jack (mini jack) for 32 ohm impedance  
earphone (for Australian models only)  
Battery life  
FM recording  
Sony R20P  
Approx. 24 hours Approx. 20 hours  
Sony LR20 alkaline Approx. 55 hours Approx. 50 hours  
Recording system  
Frequency response  
Power output  
Approx. 272 x 130 x 121.5 mm (w/ h/ d)  
3 1 7  
(10 / 4 x 5 / 8 x 4 / 8 inches) including projecting parts  
To p re ve n t fire o r sh o ck h a za rd , d o n o t e xp o se t h e p la ye r  
t o ra in o r m o ist u re .  
To a vo id e le ct rica l sh o ck, d o n o t o p e n t h e ca b in e t . Re fe r  
se rvicin g t o q u a lifie d p e rso n n e l o n ly.  
For Australian models  
Approx. 1.5 kg (3 lb 5 oz) including batteries  
for other models  
Approx. 1.7 kg (3 lb 12 oz) including batteries  
AC power cord (1) (for Australian models only)  
Power requirements  
Power consumption  
230-240 V AC, 50 Hz (for Australian models)  
Accessory supplied  
Do not install the appliance in a confined space, such as a bookcase  
or built-in cabinet.  
20 V AC, 60 Hz (for other models)  
V DC, four size D (R20) batteries  
Design and specifications subject to change without notice.  
5 W in AC operation  
To prevent fire or shock hazard, do not place objects filled with  
liquids, such as vases, on the appliance.  
The FUNCTION selector is located at the top panel.  
When you turn on the player, the OPR/ BATT indicator lights up.  
Fo r cu st o m e rs in Ca n a d a  
To prevent electric shock, match wide blade of plug to wide slot,  
fully insert.  

In addition to the user manual Sony CFM-10, we also provide a support panel to help you solve your problems with Sony CFM-10. If you have any questions, you can ask them in the form below. Other users viewing this website will have the opportunity to help you solve your probem with Sony CFM-10. Remember that you can also share the solution. If you solved the problem yourself, please write the solution to the problem with Sony CFM-10 - you will surely help many users by doing so.

Have you got problems with your device? Ask a question - our users can help you

No one has added a comment for this device/ user manual.