User manual Philips audio player SA4000 series

If you found this page, you probably have a problem and you need a user manual for the device Philips audio player SA4000 series. Be sure to check that it is the user manual to exactly the device that you are looking for. In our database Philips audio player SA4000 series it belongs to the category MP3 Player. A user manualPhilips audio player SA4000 series is taken from the manufacturer, a Philips company - it is an official document, so if you have any doubts as to its contents, please contact the manufacturer of the device Philips audio player SA4000 series directly. You can view the user manualPhilips audio player SA4000 series directly online or save and store it on your computer.

8
Frequently asked questions  
If you encounter problems with your player, go through the  
following points listed in the next section. Please also check out  
FAQs at www.philips.com/support for further help and other  
troubleshooting tips.  
My player shows  
Press and hold MENU/LOCK to activate the key press.  
.
The player does not power on and seems dead.  
Insert a new battery.  
Consult your dealer or service center if you are unable to find a  
solution by following these hints.  
Press 2; and power up your player.  
In case this does not work: Press and hold 2; while connecting the  
device to the PC. Start Device Manager, your device will be  
recovered automatically.  
Warning  
Under no circumstances should you try to repair the set yourself, as  
this will invalidate the warranty.  
The player displays: “Player problem! Connect to PC”.  
Connect your player to the PC, open Windows Explorer, open  
My computer, select your player, right click and select on Format.  
Press Start to format your player.  
My player skips songs.  
The skipped song may be protected. You may not have sufficient  
rights to play the skipped song on your player. Check the music  
rights with the song provider.  
Warning  
All contents will be erased. Backup your data before formatting.  
My player is not recognized by Windows.  
Make sure your computer is running on Windows XP (SP2 or  
higher).  
The player shows  
.
Connect your player to the computer. Delete unwanted files,  
disconnect safely and proceed with your record again.  
My player has no power or is locked up.  
Your battery may have gone flat. Insert a new battery before use.  
You may have failed to press and hold 2; long enough. Press and  
hold 2; until the Philips welcome screen appears on display.  
Do a soft reset by re-inserting the battery.  
Some songs do not show up or playback on the player.  
• The audio file might be corrupted, try to playback the file on your  
PC first. If it does not play, rip the song again.  
Songs with bit rates higher than 320kbps are not supported by the  
player.  
If none of the above works, then you may have to use the  
Device Manager to recover your player:  
• The skipped song may be protected. You may not have sufficient  
rights to play the skipped song on your player. Check the music  
rights with the song provider.  
1
Make sure the player is disconnected from PC and turned off.  
Launch the Philips Device Manager at Start > Programs >  
Philips Device Manager > Philips Device Manager on your  
PC and click Repair tab.  
2
3
4
5
6
Press and hold the )K button while your player is connecting to  
the PC.  
Keep holding the key until the Philips Device Manager  
acknowledges your player and goes into recovery mode.  
Click the repair button and follow the instructions given by the  
Device Manager.  
After the player has been repaired, disconnect it from your PC  
and re-start.  
Important  
When the first time you connect the device to PC in recovery mode,  
a hardware wizard will be popped up to install the software. Please  
select install the software automatically and click Next, and  
then click Finish to complete the installation.  
During the installation, a warning message stating "The Software you  
are installing for this hardware has not passed Windows Logo  
testing.", please select Continue Anyway, this installation will not  
affect your PC.  
There is no music on my player after transfer.  
Are your songs in MP3, WAV or WMA format?  
Other formats will not playback on the player.  
The player does not respond to any key press, and  
subsequently hangs or freezes.  
Remove and insert the battery again.  
There is no sound.  
Make sure your headphones are inserted all the way into the  
headphones jack.  
1
0
Frequently asked questions  

In addition to the user manual Philips audio player SA4000 series, we also provide a support panel to help you solve your problems with Philips audio player SA4000 series. If you have any questions, you can ask them in the form below. Other users viewing this website will have the opportunity to help you solve your probem with Philips audio player SA4000 series. Remember that you can also share the solution. If you solved the problem yourself, please write the solution to the problem with Philips audio player SA4000 series - you will surely help many users by doing so.

Have you got problems with your device? Ask a question - our users can help you

No one has added a comment for this device/ user manual.