CARE AND MAINTENANCE
ABOVE COUNTER SINK FOR USE WITH: 0621.001 STUDIO
Thank you for selecting American Standard - the benchmark of fine quality for over 100 years. To ensure this product is installed properly, please read
these instructions carefully before you begin. (Certain installations may require professional help.) Also be sure your installation conforms to local codes.
CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE!
NOTE: Pictures may not exactly define contour of china and components.
RECOMMENDED FAUCET : 2064.101 ONE lavatory faucet
Log on to www.americanstandard-us.com for additional faucet selections.
RECOMMENDED TOOLS AND MATERIALS
Channel Lock Pliers
Plumber’s Putty or Caulking
OBSERVE LOCAL PLUMBING AND BUILDING CODES
Using the template provided, locate the position of the sink
on the countertop. Provide proper clearance under the
countertop for the faucet supply lines, drain assembly and
the structural parts of the cabinet.
After checking fit
turn sink upside
down and apply a
the under side of
the rim near the
edge. Place sink in
position. Wipe off
NOTE: If replacing an existing sink be certain to shut off
water supply before removing old sink.
Drill a clearance hole inside the perimeter line of the
template for countertop installation.
Cut opening around the perimeter of the template.
Mounting holes are provided on the rear of the
lavatory so it can be secured to the wall if desired.
Mount the faucet and drain
assembly (not included) on
the sink following the
Be certain to apply a bead
of sealing putty on the
underside of the drain (Part
Connect supply line to
faucet (finger tight) and
carefully bend tubes to
engage with the supply
shut-off valves. Tighten
connections at faucet
and shut-off valves for
A”) in order to ensure a
watertight seal between the
sink and drain. Remove
excess putty after installing
drain on sink.
Connect trap to drain
assembly hand tight to
check alignment. It may
be necessary to cut off
part of the tailpiece (area
B”) or part of the
horizontal leg of the trap
area “C”). Secure joints
for watertight assembly.
Place the sink temporarily into the template.
Check for alignment and clearance.
Mark the sink and countertop in several places
as a guide for the installation location.
P r o d u c t n a m e s l i s t e d h e r e i n a r e t r a d e m a r k s o f A S A m e r i c a , I n c .
© A S A m e r i c a , I n c . 2 0 0 9
301244-100 Rev. A