User manual Winegard Satellite TV System RD-9146

If you found this page, you probably have a problem and you need a user manual for the device Winegard Satellite TV System RD-9146. Be sure to check that it is the user manual to exactly the device that you are looking for. In our database Winegard Satellite TV System RD-9146 it belongs to the category Satellite TV System. A user manualWinegard Satellite TV System RD-9146 is taken from the manufacturer, a Winegard company - it is an official document, so if you have any doubts as to its contents, please contact the manufacturer of the device Winegard Satellite TV System RD-9146 directly. You can view the user manualWinegard Satellite TV System RD-9146 directly online or save and store it on your computer.

WINEGARD®  
46 cm Portable Satellite System  
Models RD-9046/RD-9146  
Antenna Reflector at 90°  
ANTENNA/MOUNT  
MADE IN U.S.A.  
U.S. Patents 5,532,710  
& 5,646,638  
2
4° look angle  
UNPACKING/ASSEMBLY  
After unpacking the system, verify that you have a level,  
compass (attached to base), and 25 feet of coax. If you  
do not, call Winegard Company at 1-800-288-8094  
between the hours of 8:00 a.m. and 4:00 p.m. central  
time, Monday through Friday.  
SAVE THE CARTON. This carton is designed to be  
reused to store your system in when not in use.  
OPERATION  
NOTE: Disregard the compass markings, the red  
compass needle always points North. Rotate the  
base so that the other end of the needle points at the  
correctheading(direction)ontheantennabase. DO  
NOT USE THE DEGREE MARKINGS ON THE  
COMPASS.  
STEP 1. Connect coax from LNBF to receiver. If  
additionalcablelengthisrequired,useahighgradeRG-  
6/U type foam cable suitable for satellite signal and an  
FS-8100 cable splice.  
STEP 2. Plug in the receiver and TV.  
STEP 3. Turn TV and receiver ON.  
NOTE: If you have the unit sitting on a tailgate or on  
othermetalitems,itisrecommendedthatyouremove  
thecompassfromthebaseandstandaway(15'min.)  
to find the correct azimuth. Compass is attached to  
base with velcro.  
STEP 4. Tune TV to ch. 3 or 4 (to the same channel as  
the output on the receiver.)  
STEP 5. Determine azimuth (direction) and elevation  
required for your position. Refer to receiver manual.  
STEP 9. Adjust azimuth (direction) and elevation (up/  
down) for strongest signal.  
STEP 6. Loosen clamp knobs. Elevate reflector to the  
correct elevation. Align degree of elevation required  
with front of the slide bracket. Each mark indicates 5  
degrees of elevation with the first mark being 0 (mark  
closesttocompass/level). SeeFigures1and2. Tighten  
clamp knobs.  
NOTE: Ifyoudonotgetapicture,checkthefollowing:  
1.  
Make sure antenna has clear view of the high  
power satellites, no buildings, trees, etc.  
blocking the view.  
0
2.  
3.  
4.  
Make sure coax connections are good.  
Check coax for breaks, crimps, cuts etc.  
If base is not level, you will have to adjust the  
elevationtocompensate.  
STEP 7. Level base using bubble level recessed into  
the base.  
5.  
Check that TV is tuned to correct channel.  
STEP 8. Usingcompassrecessedintobase,rotatethe  
base slowly (3 increments) to the desired azimuth  
o
CAUTION: DONOTDROPSYSTEM. IFANTENNAIS  
DAMAGED,ITWILLREDUCETHEGAIN(HOWMUCH  
SIGNAL THE ANTENNA SENDS TO THE RECEIVER)  
OF THE ANTENNA. THIS CAN RESULT IN A  
DEGRADED PICTURE.  
(
direction) for the high power satellites. The signal is  
digital, you must wait a few seconds after each move to  
allow the receiver to process the signal.  

In addition to the user manual Winegard Satellite TV System RD-9146, we also provide a support panel to help you solve your problems with Winegard Satellite TV System RD-9146. If you have any questions, you can ask them in the form below. Other users viewing this website will have the opportunity to help you solve your probem with Winegard Satellite TV System RD-9146. Remember that you can also share the solution. If you solved the problem yourself, please write the solution to the problem with Winegard Satellite TV System RD-9146 - you will surely help many users by doing so.

Have you got problems with your device? Ask a question - our users can help you

No one has added a comment for this device/ user manual.