Thank you for purchasing an Onkyo home theater speaker package. Please read this manual thoroughly
before using your new speakers. Following the instructions in this manual will enable you to obtain opti-
mum performance and listening enjoyment from your speaker package.
Please retain this manual for future reference.
. AC Fuse
As the colours of the wires in the mains lead of this
apparatus may not correspond with the coloured mark-
ings identifying the terminals in your plug, proceed as
The fuse is located inside the chassis and is not userser-
viceable. If power does not come on, contact your Onkyo
authorized service station.
The wire which is coloured blue must be connected to
the terminal which is marked with the letter N or
The wire which is coloured brown must be connected to
the terminal which is marked with the letter L or
From time to time you should wipe off the cabinet with a
soft cloth. For heavier dirt, dampen a soft cloth in a weak
solution of mild detergent and water, wring it out dry, and
wipe off the dirt. Following this, dry immediately with a
clean cloth. Do not use rough material, thinners, alcohol
or other chemical solvents or cloths since these may dam-
age the ﬁnish or remove the panel lettering.
The plug is ﬁtted with an appropriate fuse. If the fuse
needs to be replaced, the replacement fuse must
approved by ASTA or BSI to BS1362 and have the same
ampere rating as that indicated on the plug. Check for
the ASTA mark or the BSI mark on the body of the fuse.
If the power cord’s plug is not suitable for your socket
outlets, cut it off and ﬁt a suitable plug. Fit a suitable
fuse in the plug.
Use a vacuum cleaner to remove dust from hard-to-reach
BEFORE PLUGGING IN THE UNIT FOR THE
FIRST TIME, READ THE FOLLOWING SECTION
The voltage of the available power supply differs
according to country or region. Be sure that the power
supply voltage of the area where this unit will be used
meets the required voltage (e.g., AC 120 V, 60 Hz) writ-
ten on the rear panel.
For European Models
Declaration of Conformity
Auto standby function does not fully shutdown the
SKW-530. If you do not intend to use the SKW-530,
remove the power cord from the AC outlet.
We, ONKYO EUROPE
For British models
Replacement and mounting of an AC plug on the power
supply cord of this unit should be performed only by
qualiﬁed service personnel.
declare in own responsibility, that the ONKYO product
described in this instruction manual is in compliance with the
technical standards such as EN60065,
EN55013, EN55020 and EN61000-3-2, -3-3.
The wires in the mains lead are coloured in accordance
with the following code:
ONKYO EUROPE ELECTRONICS GmbH
Attaching and detaching the speaker grilles
Front and Center speakers have detachable grilles. Use the
following method to attach or detach the grilles.
. While holding the bottom edge of the speaker grille
with your both hands, pull it gently toward you to
remove the bottom of the grille.
. In the same way, gently pull the upper edge of the
speaker grille toward you to remove it from the main
. To replace the grill, push the projections at the corners
into the grille plug holes on the speaker cabinet.