User manual Toro 640

If you found this page, you probably have a problem and you need a user manual for the device Toro 640. Be sure to check that it is the user manual to exactly the device that you are looking for. In our database Toro 640 it belongs to the category Sprinkler. A user manualToro 640 is taken from the manufacturer, a Toro company - it is an official document, so if you have any doubts as to its contents, please contact the manufacturer of the device Toro 640 directly. You can view the user manualToro 640 directly online or save and store it on your computer.

Reinstalling Nozzle/Drive Assembly  
1. Part Circle Only: Holding drive assembly stationary, slowly rotate nozzle assembly counterclockwise to left side of arc pattern  
(see Figure 6).  
2
. Check drive assembly key tab for approximately 30° upward bend, adjust if necessary (see Figure 7).  
. Insert nozzle/drive assembly into body until seal is approximately one (1) inch below top of body.  
Part Circle Only: Align main nozzle orifice with left edge of watering arc before inserting (see Figure 8).  
. Place nozzle retainer over nozzle assembly aligning keyway and drive assembly key (see Figure 9).  
3
4
FIGURE 6  
FIGURE 7  
FIGURE 8  
Drive  
Assembly Key  
1"  
Rotate  
Counterclockwise  
FIGURE 9  
Nozzle Retainer  
Keyway  
(Shaded Area)  
5
. Rotate nozzle retainer, interlocked  
with nozzle/drive assembly, to align  
the nearest of six (6) alignment slots  
with tabs on body (see Figure 10).  
Drive  
Assembly  
Key  
6. Press retainer into body to interlock  
alignment slot and body tab.  
Nozzle Retainer  
Keyway  
7
. Install riser seal over nozzle  
assembly placing peg into retainer  
keyway (see Figure 11).  
FIGURE 10  
FIGURE 11  
Riser  
8
. Install cap and secure with set  
screw.  
9
. Check watering arc. If minor  
adjustments are required (1/6 of a  
turn or less); rotate sprinkler body  
on riser. Do not make adjustments  
by turning nozzle assembly (see  
CAUTION below).  
Seal Peg  
Body  
Tab  
Nozzle  
Retainer  
Keyway  
CAUTION  
Rotating nozzle assembly to  
make watering arc adjustments  
may cause severe internal  
damage to drive assembly.  
Alignment Slots  
Note: Refer to Illustrated Parts  
Breakout Book Form No. 368-0044  
for current parts listing.  
©
1998 THE TORO COMPANY  
Irrigation Division • An ISO 9001-Certified Facility  
P.O. Box 489 • Riverside, CA 92502  
Printed in U.S.A.  
4
PRINTING DATE  
FEBRUARY 1998 REV. E  
PART NO.  
362-0052  

In addition to the user manual Toro 640, we also provide a support panel to help you solve your problems with Toro 640. If you have any questions, you can ask them in the form below. Other users viewing this website will have the opportunity to help you solve your probem with Toro 640. Remember that you can also share the solution. If you solved the problem yourself, please write the solution to the problem with Toro 640 - you will surely help many users by doing so.

Have you got problems with your device? Ask a question - our users can help you

No one has added a comment for this device/ user manual.