If you found this page, you probably have a problem and you need a user manual for the device Ashly ne 8250.70. Be sure to check that it is the user manual to exactly the device that you are looking for. In our database Ashly ne 8250.70 it belongs to the category Stereo Amplifier. A user manualAshly ne 8250.70 is taken from the manufacturer, a Ashly company - it is an official document, so if you have any doubts as to its contents, please contact the manufacturer of the device Ashly ne 8250.70 directly. You can view the user manualAshly ne 8250.70 directly online or save and store it on your computer.

Operating Manual - NE Multi Channel Power Amplifiers  

Physical Description  

Each model in the NE Multichannel series is 2RU, and weighs 22 pounds (10kg) or less. The model number is  

indicated in the lower left corner of the front panel.  

Amplifier Front Panel  

1

2

3

4

5

6

. Mounting Holes – For rack mounting.  

. Power Switch – Switches the unit on or off. Note: The power switch can be disabled from Protea^ne Software  

. Status LEDs – Indicate status of: Power, Standby, Protect, Power Switch Disable, and Comm activity  

. Air Inflow Vents – Cool air enters here  

. Channel Controls – Channel control area  

. Signal LEDs – The lowest LED will begin to light when the output voltage reaches -18dBu below rated output.  

The Clip LEDs will begin to flash when output voltage is 1/2 volt below the output power supply voltage.  

7

8

. Bridge – This LED indicates that the channel pair is selected to BRIDGE mode from the back panel switch, and  

that only the odd input channel level control is active  

. Temp and Current LEDs – The Temp LED indicates that the amplifier has reached an excessively high  

operating temperature. The Current LED confirms that the amplifier output is delivered to a speaker load.  

9

1

. Channel Attenuators – These control the input signal level to the amp, and can be disabled from software.  

0. Factory Reset – To reset all internal configurations (including passwords) back to their original factory set-  

tings, press and hold this recessed front panel tact switch during power up until all channel LEDs are lit. Upon reset  

completion, the LEDs will turn off and the amp will be in normal operating mode.  

Amplifier Rear Panel  

Model shown: ne8250 with Cobranet and AES/EBU options  

6

• ← Previous
• Next page →

In addition to the user manual Ashly ne 8250.70, we also provide a support panel to help you solve your problems with Ashly ne 8250.70. If you have any questions, you can ask them in the form below. Other users viewing this website will have the opportunity to help you solve your probem with Ashly ne 8250.70. Remember that you can also share the solution. If you solved the problem yourself, please write the solution to the problem with Ashly ne 8250.70 - you will surely help many users by doing so.