If you found this page, you probably have a problem and you need a user manual for the device Ashly ne 8250.70. Be sure to check that it is the user manual to exactly the device that you are looking for. In our database Ashly ne 8250.70 it belongs to the category Stereo Amplifier. A user manualAshly ne 8250.70 is taken from the manufacturer, a Ashly company - it is an official document, so if you have any doubts as to its contents, please contact the manufacturer of the device Ashly ne 8250.70 directly. You can view the user manualAshly ne 8250.70 directly online or save and store it on your computer.

Operating Manual - NE Multi Channel Power Amplifiers  

The WR-5 is a microprocessor based remote  

control unit which can be used with the NE multi-  

channel amplifiers. The WR-5 is designed to fit into  

a standard electrical wall box. Up to four WR-5  

remotes can be phantom powered from one ampli-  

fier, and adding more remotes is possible using an  

external power supply. Each of six buttons on the  

WR-5 can be programmed to engage one of the fol-  

lowing functions:  

1

2

3

4

5

) Preset recall  

) Preset scroll  

) Channel volume  

) Channel mute  

) Zone input source selection (requires DSP)  

Programming of each button is done from Pro-  

tea Software when the WR-5 is wired to its host NE am-  

plifier, and the amplifier is connected to a PC via ethernet.  

Up to four WR-5 units can be daisy-chained from the same  

amplifier. See your Ashly dealer or visit the Ashly web  

site at www.ashly.com for more WR-5 details.  

Ashly WR-5 Remote Control  

Ashly RD-8C Remote Control  

RD-8C or RW-8C Remote Control  

A second microprocessor based controller, the Ashly  

RD-8C, is an eight channel wall mount level controller  

that uses slide faders for individual channel and master  

level control and mute. NOTE: When an RD-8C is used,  

no other microprocessor based remotes can be used.  

Ashly WR-1 Remote Attenuator  

WR-1 Remote Level Control  

Individual amplifier channels can have remote level  

control using a potentiometer assembly such as the Ashly  

WR-1 and four conductor wire. The WR-1 is a dual po-  

tentiometer remote volume control designed to fit in a stan-  

dard wall electrical box. Each volume control is connected  

to a terminal block on the WR-1 circuit board, which in  

turn must be wired to the amplifier back panel euroblock  

connector labeled "Remote Level Control" as shown. Do  

not connect the WR-1 remote level control ground to any  

other external grounds.  

G

G

CV-2  

CV-1  

+

5

+5  

9

• ← Previous
• Next page →

In addition to the user manual Ashly ne 8250.70, we also provide a support panel to help you solve your problems with Ashly ne 8250.70. If you have any questions, you can ask them in the form below. Other users viewing this website will have the opportunity to help you solve your probem with Ashly ne 8250.70. Remember that you can also share the solution. If you solved the problem yourself, please write the solution to the problem with Ashly ne 8250.70 - you will surely help many users by doing so.