If you found this page, you probably have a problem and you need a user manual for the device Extron electronic WM EC F. Be sure to check that it is the user manual to exactly the device that you are looking for. In our database Extron electronic WM EC F it belongs to the category Stereo Amplifier. A user manualExtron electronic WM EC F is taken from the manufacturer, a Extron electronic company - it is an official document, so if you have any doubts as to its contents, please contact the manufacturer of the device Extron electronic WM EC F directly. You can view the user manualExtron electronic WM EC F directly online or save and store it on your computer.

Controls and Installation, cont’d  

6

7

Power up all of the input and output devices.  

The image should now display on screen. If it does not,  

double check steps 3 through 6 and make adjustments as  

needed. Refer to the section “Setting the DIP switches” in  

this chapter.  

NOTE Do not disassemble the dogleg  

from the dogleg screw. Rotate the  

dogleg out of the way to insert the  

mud ring into the wall.  

8

For the P/2 DA2 WM F, attach the P/2 DA2 WM F to the  

wall mounting bracket (see “Installing the mud ring  

bracket”).  

Dogleg  

Screw  

For the P/2 DA2 WM EC F, attach the P/2 DA2 WM F EC  

to the Euro Channel (see “P/2 DA2 WM EC F Euro  

Channel installation”).  

Extron  

MR 200D  

Modular Mud Ring  

Installing the mud ring bracket  

Rotate doglegs  

and insert mud  

ring into wall  

opening.  

1.  

Once the proper wall location for mounting the  

distribution amplifier has been determined, cut an opening  

in the wall using the proper mounting template found in  

the appendix.  

Surface Mounting  

Hole  

2

.

.

Carefully cut away the mounting surface material inside  

the traced template lines.  

Equipment Mounting  

Holes  

3

Test the fit of the mud ring. The doglegs should fit easily  

into the hole and the flat portion should rest flush against  

the wall. See the note in the following illustration.  

Installing a mud ring bracket  

4.  

5.  

6.  

Rotate all doglegs inward.  

Insert the mud ring into the hole.  

Tighten all of the dogleg screws until the doglegs clamp  

the mud ring to the mounting surface. Do not  

overtighten.  

Standard mud rings only: If you are going to screw the  

mud ring to the surface, rather than using the detachable  

doglegs, mark the four surface mounting screw holes at  

the corners of the mud ring.  

2

-8  

P/2 DA2 WM/EC/D/AAP Series • Controls and Installation  

P/2 DA2 WM/EC/D/AAP Series • Controls and Installation  

2-9  

• ← Previous
• Next page →

In addition to the user manual Extron electronic WM EC F, we also provide a support panel to help you solve your problems with Extron electronic WM EC F. If you have any questions, you can ask them in the form below. Other users viewing this website will have the opportunity to help you solve your probem with Extron electronic WM EC F. Remember that you can also share the solution. If you solved the problem yourself, please write the solution to the problem with Extron electronic WM EC F - you will surely help many users by doing so.