User manual Allied Telesis Switch X900-24XS

If you found this page, you probably have a problem and you need a user manual for the device Allied Telesis Switch X900-24XS. Be sure to check that it is the user manual to exactly the device that you are looking for. In our database Allied Telesis Switch X900-24XS it belongs to the category Switch. A user manualAllied Telesis Switch X900-24XS is taken from the manufacturer, a Allied Telesis company - it is an official document, so if you have any doubts as to its contents, please contact the manufacturer of the device Allied Telesis Switch X900-24XS directly. You can view the user manualAllied Telesis Switch X900-24XS directly online or save and store it on your computer.

x900 Series Switch and SwitchBlade® x908  
Using the AlliedWare Plus Operating System GUI  
Follow this procedure to establish a connection to an x900 or x908 series  
switch, so you can use the GUI to configure the switch.  
1
. Select a PC to use and identify its subnet.  
You can browse to the switch from any PC running a supported operating  
system with a supported browser with JavaScript enabled. You may need to  
install and run the latest Java Runtime Environment that you can download  
from the Sun site so your browser can support the GUI Java applet.  
2
. Connect the PC to the switch.  
Use an Ethernet cable to connect an Ethernet card on the PC to any of the  
switch ports. You can browse to the router through any VLAN as long as  
you give it an IP address. These instructions assume you are using vlan1. All  
switch ports belong to vlan1 by default.  
3
4
. Access the CLI from the PC as described in “Using the AlliedWare Plus  
Operating System CLI” on page 17.  
. Assign an IP address to connect to the GUI using these CLI commands:  
awplus>enable  
awplus#configure terminal  
awplus(config)#interface vlan1  
awplus(config-if)#ip address <address/mask>  
where <address/mask> is an IP address and mask in slash notation, for  
example 192.168.242.242/24.  
5
6
. Configure your switch with a default gateway using these CLI commands:  
awplus(config-if)#exit  
awplus(config)#ip route 0.0.0.0/0 <gateway-address>  
where <gateway-address> is an IP address for your gateway device.  
Note that you do not need to define a default gateway if you browse to the  
switch from within its own subnet.  
. Create a user account to log into the GUI using the below CLI command:  
awplus(config)#username <username> privilege 15  
guiuser password <password>  
Note that you can create multiple users to log into the GUI. See the  
AlliedWare Plus Software Reference for information about the username  
command and all other AlliedWare Plus CLI commands shown here.  
2
0

In addition to the user manual Allied Telesis Switch X900-24XS, we also provide a support panel to help you solve your problems with Allied Telesis Switch X900-24XS. If you have any questions, you can ask them in the form below. Other users viewing this website will have the opportunity to help you solve your probem with Allied Telesis Switch X900-24XS. Remember that you can also share the solution. If you solved the problem yourself, please write the solution to the problem with Allied Telesis Switch X900-24XS - you will surely help many users by doing so.

Have you got problems with your device? Ask a question - our users can help you

No one has added a comment for this device/ user manual.