User manual HP (Hewlett-Packard) JD312B

If you found this page, you probably have a problem and you need a user manual for the device HP (Hewlett-Packard) JD312B. Be sure to check that it is the user manual to exactly the device that you are looking for. In our database HP (Hewlett-Packard) JD312B it belongs to the category Switch. A user manualHP (Hewlett-Packard) JD312B is taken from the manufacturer, a HP (Hewlett-Packard) company - it is an official document, so if you have any doubts as to its contents, please contact the manufacturer of the device HP (Hewlett-Packard) JD312B directly. You can view the user manualHP (Hewlett-Packard) JD312B directly online or save and store it on your computer.

NOTE:  
The hotkeys in Table 3 are defined by the switch. If the same hotkeys are defined by the terminal software  
that you use to interact with the switch, the hotkeys defined by the terminal software take effect.  
Redisplaying input but not submitted commands  
If your command input is interrupted by output system information, you can use this feature to redisplay  
the commands input previously but not submitted.  
Follow these steps to enable redisplaying of commands previously input but not submitted:  
To do…  
Use the command…  
system-view  
Remarks  
Enter system view  
Required  
Enable redisplaying of input but  
not submitted commands  
info-center synchronous  
Disabled by default  
NOTE:  
If you have no input at the command line prompt and the system outputs system information such as  
logs, the system will not display the command line prompt after the output.  
If the system outputs system information when you are typing interactive information (not YES/NO for  
confirmation), the system does not redisplay the prompt information but a line break after the output and  
then display what you have typed.  
For more information about the info-center synchronous command, see the Network Management and  
Monitoring Configuration Guide.  
Checking command-line errors  
If a command contains syntax errors, the CLI reports error information.  
Table 4 Common command line errors  
Error information  
Cause  
%
Unrecognized command found at '^' position. The command was not found.  
%
%
Incomplete command found at '^' position.  
Ambiguous command found at '^' position.  
Incomplete command  
Ambiguous command  
Too many parameters  
Wrong parameters  
Too many parameters  
Wrong parameter found at '^' position.  
%
Using command history  
The CLI automatically saves the commands recently used in the history command buffer. You can access  
these commands and execute them again.  
8

In addition to the user manual HP (Hewlett-Packard) JD312B, we also provide a support panel to help you solve your problems with HP (Hewlett-Packard) JD312B. If you have any questions, you can ask them in the form below. Other users viewing this website will have the opportunity to help you solve your probem with HP (Hewlett-Packard) JD312B. Remember that you can also share the solution. If you solved the problem yourself, please write the solution to the problem with HP (Hewlett-Packard) JD312B - you will surely help many users by doing so.

Have you got problems with your device? Ask a question - our users can help you

No one has added a comment for this device/ user manual.