Manuel d'utilisation 3M Company Flooring

Si vous arrivez à cette page, vous avez probablement un problème, et vous avez besoin de manuel du dispositif 3M Company Flooring. Soyez sûr de vérifier qu'il s'agit exactement de manuel du dispositif que vous cherchez. Dans notre base de données 3M Company Flooring il appartient à la catégoriePlancher. Le manuel d'utilisation 3M Company Flooring vient du fabricant, l'entreprise 3M Company - c'est un document officiel, et si vous avez des doutes quant à son contenu, s'il vous plaît contacter directement le fabricant 3M Company Flooring. Le manuel 3M Company Flooring peut être visualisé directement en ligne, ou enregistré et stocké sur votre ordinateur.

StrataMax Installation System  
General Information  
StrataMax flooring can be installed by two installation methods. It is designed as a lay flat  
structure when installed by the modified loose lay installation method using acrylic double-face  
tape under seams. It can also be installed by the traditional full spread method using S-288  
adhesive over approved substrates and underlayments. The modified loose lay method requires  
that the flooring be cut 1/8" to 3/16" away from all vertical surfaces such as walls, cabinets, pipes,  
etc. This gap must then be filled with a good quality siliconized or acrylic caulk.  
Transport and store flooring rolled face out on a cardboard tube, do not kink or distort.  
Always roll flooring face out until ready to install.  
Do not use products containing petroleum solvents or citrus oils to prepare substrates.  
Just prior to installation, lay flooring out flat to acclimate to conditions and allow the roll-  
up stresses to relax.  
Flooring and room temperature should be a minimum of 65 degrees F (18 degrees C) for  
48 hours before installation, during installation, and 48 hours after installation. Minimum  
5 degrees F (13 degrees C) thereafter.  
5
Plan layout for minimum number of seams.  
Accurately measure length and width of room. Included recessed areas/doorways.  
Allow an extra 1-1/2" of flooring on each end for trimming.  
If more than one piece of flooring is needed, allow for correct pattern match at seam.  
Suitable Substrates  
All substrates listed below must be properly prepared and meet certain requirements. There may  
be exceptions and special conditions for these substrates to be suitable for StrataMax flooring  
installation. (Refer to the Subfloors and Underlayment section of the Armstrong Guaranteed  
Installation Systems manual, F5061, for more details. Or visit www.floorexpert.com.)  
Concrete (on all grade levels)  
Approved suspended wood underlayments  
Single-layer, fully adhered, existing resilient floors  
Ceramic tile, terrazzo, marble  
Polymeric poured (seamless) floors  
StrataMax, because of its unique structure and design, can also be installed directly over  
suspended single-layer wood subfloors such as plywood or oriented strand board (OSB) when  
using the modified loose lay method. The subfloor system must be designed to meet or  
exceed applicable building codes with a minimum of 18" well-ventilated air space below. The  
subfloor panels should have a smooth, sanded face and show no swelling of edges or surface  
due to exposure to weather conditions or construction traffic. The panels can not be contaminated  
by staining agents. Otherwise, an additional 1/4" or thicker underlayment is recommended.  
Single-layer wood subfloors increase the potential for staining from the panel components, coated  
nails, construction adhesives, spills, overspray and show-through from texture and mechanical or  
water damage when resilient flooring is installed directly over them.  

En plus du manuel 3M Company Flooring, nous fournissons également des panneaux d'assistance qui vous aideront à résoudre vos problèmes avec 3M Company Flooring. Si vous avez des questions, vous pouvez les poser dans le formulaire ci-dessous. Les autres utilisateurs qui viennent ici, auront l'occasion de vous aider à résoudre votre problème3M Company Flooring.

Problème avec le dispositif? Posez une question, nos utilisateurs peuvent aider

Personne n'a ajouté commentaire pour ce dispositif/manuel.