If you found this page, you probably have a problem and you need a user manual for the device Wilton PF3-EZ. Be sure to check that it is the user manual to exactly the device that you are looking for. In our database Wilton PF3-EZ it belongs to the category Saw. A user manualWilton PF3-EZ is taken from the manufacturer, a Wilton company - it is an official document, so if you have any doubts as to its contents, please contact the manufacturer of the device Wilton PF3-EZ directly. You can view the user manualWilton PF3-EZ directly online or save and store it on your computer.

NOTE: The handle can be pivoted out of the  

way if necessary. Lift up on the handle,  

rotate the handle on its pin, then release the  

handle, making sure it fully seats itself on  

the pin.  

1

6. Mount the stock feeder to the elevating  

column by sliding the stud of the stock  

feeder into the hole of the pivot joint (Figure  

6

). Install the remaining flat washer and  

handle onto the stud, and tighten the  

handle.  

Grounding Instructions  

Electrical connections must  

be made by  

a

qualified electrician in  

compliance with all relevant codes. This  

machine must be properly grounded to help  

prevent electrical shock and possible fatal  

injury.  

As received from the factory, the PF3-EZ Stock  

Feeder will run on either 230 volt or 460 volt,  

depending upon your particular model. Make  

sure the voltage of your power supply matches  

the specifications on the motor plate of the  

Stock Feeder.  

Figure 6  

You may either connect an appropriate UL/CSA  

listed plug or “hard-wire” the machine directly to  

a control panel. If hard-wired to a panel, make  

sure a disconnect is available for the operator.  

The Stock Feeder must comply with all local and  

national codes after being wired. If it is to be  

hard-wired, make sure the fuses have been  

removed or the breakers have been tripped in  

the circuit to which the Stock Feeder will be  

connected. Place a warning placard on the fuse  

holder or circuit breaker to prevent it being  

turned on while the machine is being wired.  

Refer to “Electrical Connections” on page 25 for  

connecting the motor leads.  

This machine must be grounded. In the event of  

a malfunction or breakdown, grounding provides  

a path of least resistance for electric current, to  

reduce the risk of electric shock to the operator.  

Improper connection of the equipment-  

grounding conductor can result in a risk of  

electric shock. The conductor, with insulation  

having an outer surface that is green with or  

without yellow stripes, is the equipment-  

grounding conductor. If repair or replacement of  

the electric cord or plug is necessary, do not  

connect the equipment-grounding conductor to a  

live terminal.  

Repair or replace a damaged or worn cord  

immediately.  

11  

• ← Previous
• Next page →

In addition to the user manual Wilton PF3-EZ, we also provide a support panel to help you solve your problems with Wilton PF3-EZ. If you have any questions, you can ask them in the form below. Other users viewing this website will have the opportunity to help you solve your probem with Wilton PF3-EZ. Remember that you can also share the solution. If you solved the problem yourself, please write the solution to the problem with Wilton PF3-EZ - you will surely help many users by doing so.