User manual Quantum Instruments MS3580

If you found this page, you probably have a problem and you need a user manual for the device Quantum Instruments MS3580. Be sure to check that it is the user manual to exactly the device that you are looking for. In our database Quantum Instruments MS3580 it belongs to the category Scanner. A user manualQuantum Instruments MS3580 is taken from the manufacturer, a Quantum Instruments company - it is an official document, so if you have any doubts as to its contents, please contact the manufacturer of the device Quantum Instruments MS3580 directly. You can view the user manualQuantum Instruments MS3580 directly online or save and store it on your computer.

INSTALLATION  
RS232, RS232 TTL, Light Pen or Laser Emulation  
1. Turn off the host device.  
2. Plug the male 10-pin RJ45 end  
of the PowerLink cable into the  
10-pin socket on the MS3580.  
3. Connect the 9-pin female end of the  
PowerLink cable to the host device.  
4. Plug the external power supply into the  
power jack on the PowerLink cable.  
Check the AC input requirements  
of the power supply to make sure  
the voltage matches the AC outlet.  
The outlet must be located near  
the equipment and be easily  
accessible.  
5
. Connect AC power to the transformer.  
. Turn on the host device.  
6
Figure 8.  
When the scanner first receives power, the blue LED will turn on; the  
scanner will simultaneously emit a beep and flash the white LED.  
Plugging the scanner into the serial port of the PC does not guarantee  
that scanned information will appear at the PC. A software driver and  
correct configuration setting are also required for proper  
communication to occur.  
The MS3580-104 leaves the factory with the Laser Emulation  
enabled. If the Recall Defaults bar code is scanned while  
reconfiguring the scanner, laser emulation will no longer be enabled.  
Scan the Laser Emulation barcode in Section J: Laser Emulation of  
the MetroSelect Configuration Guide to re-enable the laser emulation  
interface. This feature is only supported for MS3580-104 models.  
Caution  
To maintain compliance with applicable standards, all circuits connected to the scanner  
must meet the requirements for SELV (Safety Extra Low Voltage) according to EN/IEC  
60950.  
To maintain compliance with standard CSA C22.2 No. 60950/UL 60950 and norm  
EN/IEC 60950, the power source should meet applicable performance requirements for  
a limited power source.  
8

In addition to the user manual Quantum Instruments MS3580, we also provide a support panel to help you solve your problems with Quantum Instruments MS3580. If you have any questions, you can ask them in the form below. Other users viewing this website will have the opportunity to help you solve your probem with Quantum Instruments MS3580. Remember that you can also share the solution. If you solved the problem yourself, please write the solution to the problem with Quantum Instruments MS3580 - you will surely help many users by doing so.

Have you got problems with your device? Ask a question - our users can help you

No one has added a comment for this device/ user manual.